Either, or have if kind of sideways and it swings out and down. Could be flat against the rear of the cab, where the spare goes, or cut and weld a notch on one side of the bed and hold it sideways vertically there. Plenty of options................I totally agree!!! That would be awesome. The funny thing is a few years back I was well on my way to building a Jet powered go-kart.
The Bat mobile had a jet engine. Should I have it drop put from the undercarriage, or a special lift out from the bed?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
My 2hr project (finished at midnight)
- Thread starter crazywelder72
- Start date
- 3,724
- 782
- 113
- Location
- Michigan
Thats a cool mod. The horn button puts the cherry in the juice...!
Lothar
Well-known member
- 319
- 659
- 93
- Location
- North Arkansas
I like it. You must have boosted your horsepower by at least 10
Last edited:
crazywelder72
New member
- 701
- 2
- 0
- Location
- Winchester Ma
Easly 10HP gain. As soon as i get some decals on it I am sure to gain more. I cant wait to get it on the dyno and see the before and after results.
Trango
Member
- 735
- 22
- 18
- Location
- Boulder, CO
Nice! Also good to see another home machinist on the board.
For the other tool junkies, here's a quick video I shot this weekend. I am working with some #80 roller chain sprockets, and I needed to open up the ID on one:
VID-20120422-00003 - YouTube
Best,
Bob
For the other tool junkies, here's a quick video I shot this weekend. I am working with some #80 roller chain sprockets, and I needed to open up the ID on one:
VID-20120422-00003 - YouTube
Best,
Bob
crazywelder72
New member
- 701
- 2
- 0
- Location
- Winchester Ma
I think there are more machinists/fabricators/welders on here than you think. ![[thumbzup]](https://www.steelsoldiers.com/images/smilies/icon_smile_thumzup.gif "Thumbs Up [thumbzup]")
crazywelder72
New member
- 701
- 2
- 0
- Location
- Winchester Ma
This is my Logan lathe. not the best pic and far from the cleanest shop
