@fuzzytoaster or @Csm Davis may have some A2 style. They are slanted
Air lines are standard commercial coil type
Last edited:
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
New Purchase Globe 10 ton trailer
- Thread starter Norinco666
- Start date
Air lines are standard commercial coil type
- 7,347
- 19,032
- 113
- Location
- Charlotte NC
.
I am guessing the bumperettes are for the M936?
Csm Davis might be a good source.
He has plenty of wrecker parts.
Norinco666
Member
- 79
- 77
- 18
- Location
- Alabama
Im sorry i should have been more specific im looking for the air lines
- 7,347
- 19,032
- 113
- Location
- Charlotte NC
.
Is it the plastic lines that feed air to the axles?
Maybe a picture just in case?
If you need that black plastic line, it is a DOT Approved line that needs to be replaced with same. TruckPro is a good source. NAPA could also be an option where you are. It is just standard air supply line. Reasonably cheap and don't hesitate to get extra so you can have some in your towing vehicle in case you need it.
Norinco666
Member
- 79
- 77
- 18
- Location
- Alabama
Its the 2 rubber lines with the glad hands attached that hook up to back of truck ill have to grab a pic this weekend
Just use coil lines and run them thru the handle on the front of the neck then around your bumperettes it will push the line along that smooth bumperette and not pinch as it's higher than the trailer frame
If you use rubber again run them thru the drain holes in the box out the bottom and loop them down and to the truck so they clear the swing