Gamagoat1
Active member
- 745
- 43
- 28
- Location
- Kiowa, Colorado
Any one know what thickness gasket is reqired to achieve proper gear spacing between the transmission pto and its drive gear in the transmission?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
PTO Gasket
- Thread starter Gamagoat1
- Start date
- 34,014
- 1,814
- 113
- Location
- GA Mountains
There is no specific gasket thickness. You have to install it, check the backlash and adjust accrodingly. I try to keep a few of each size here so I can get it done in one try.
Gamagoat1
Active member
- 745
- 43
- 28
- Location
- Kiowa, Colorado
What is the proper was to check backlash?
- 34,014
- 1,814
- 113
- Location
- GA Mountains
Proper way is with the tranny on the floor. You can remove the outer cover of the PTO and position a mag base and dial indicator to check it. I do mine by feel basically reaching in the PTO once bolted on and rocking the inner gear back ans forth. As long as it has free play, I run it. A little to much is better than a little to little.
Gamagoat1
Active member
- 745
- 43
- 28
- Location
- Kiowa, Colorado
Thanks Kenny!!
DanMartin
New member
- 1,276
- 16
- 0
- Location
- Hillsboro, Oregon (USA)
Where does one get a set of various thickness gaskets?
- 26,247
- 1,168
- 113
- Location
- NY
Napa or Fleetpride http://fleetpride.com/fp_p/branch.htmlDanMartin said:
I did a search for "pto gasket" and there were 19 results. This one has some real good info. http://www.steelsoldiers.com/index.php?name=PNphpBB2&file=viewtopic&t=8274&highlight=pto+shim