optiklaus
New member
- 9
- 0
- 1
- Location
- connecticut
Just had a new 4L80e trans put in a 2014 M1097 and trans mil light does not illuminate when ignition is keyed on. Engine starts and runs great. Fells like its stuck in 2nd gear though. I soon discovered Trans circuit breaker pops as soon as ignition is keyed on. I disconnected all trans wires and sensors, disconnected transfer case wires, disconnected TCM, and the breaker still pops immediately when ignition is keyed on. I substituted a homemade 15 amp breaker and that blew as well. Trans relay is out putting 12v , but could it still be bad? Ordered a new relay and the negative shunt to try and eliminate any variables I could think of. Ive read through some of the other great threads about transmission diagnosing on here, but I can't find any that mention this circuit breaker tripping , so I was hoping someone out there could help. Thanks