-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Latest activity
What's new
BMI
Midwest Military Equipment
Eastern Surplus & Equipment Co
-
Most states won’t left tracked vehicles even with pads on their hwys . I went thru this in Louisiana when I was hashing out the bill for... -
Cleared out another area in my yard so I can set up a storage rack for the oak boards.
-
Guyfang replied to the thread M548a1 fixing up.Not an uncommon problem. -
Most states won’t left tracked vehicles even with pads on their hwys . I went thru this in Louisiana when I was hashing out the bill for...
-
I had one of these years ago . Showed 60 miles or hours on it i forget . Came from city of New Orleans . Old guy with city said it was...
-
AAl Capone replied to the thread M548a1 fixing up.I had one of these years ago . Showed 60 miles or hours on it i forget . Came from city of New Orleans . Old guy with city said it was...
-
AAl Capone replied to the thread M548a1 fixing up.Most states won’t left tracked vehicles even with pads on their hwys . I went thru this in Louisiana when I was hashing out the bill for...
-
CSound like you are losing power between MT4 and S1-3 Try the following 1) Put Dead Crank in the NORMAL position. 2) Put S1 in PRIME/RUN...
-
CIt looks like CR1 is bad. To verify that put a jumper between the two leads of CR1 to bypass it. See if the generator crank properly...
-
CGood work being persistent everyone! As soon as I first read this post I thought CR-1 but OP said it was good, so I immediately checked...
-
KGood work being persistent everyone! As soon as I first read this post I thought CR-1 but OP said it was good, so I immediately checked...
-
RRay70 replied to the thread MEP-802A no crank/no power.Good work being persistent everyone! As soon as I first read this post I thought CR-1 but OP said it was good, so I immediately checked...
-
RRay70 replied to the thread 803A engine help.Don't worry about the head gasket thickness, my experience has been that using the "standard" thickness gasket that comes in the gasket...
-
Tinstar replied to the thread M1008 radiator replacement.Do not waste your money on a 2 row. Even without towing. I would take it to another repair shop and see what they say. If not, be... -
Sspark500001 replied to the thread 803A engine help.Update: we removed the cylinder head and found no damage to the piston domes and valves. we have a few questions: how do we determine...
