-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Latest activity
What's new
BMI
Midwest Military Equipment
Eastern Surplus & Equipment Co
-
Aazreark1 replied to the thread MEP-114A GPU.So the GPU box is a Hobart TR-1528, snagged a manual and was going through it. The panel is missing a switch so referenced the manual...
-
Scoobyshep replied to the thread MEP-114A GPU.I built a heater for my 004 which consists of three water heater elements that I just submerge in a tank of water. Without factoring in... -
Aazreark1 replied to the thread MEP-114A GPU.Yeah i don't think i have access to anything but an airplane that could actually stress test this unit.
-
Scoobyshep replied to the thread MEP-114A GPU.Pretty much anything without a motor would be the general blanket statement. Heaters and incandescent light bulbs really don't care...
-
Aazreark1 replied to the thread MEP-114A GPU.So…what can i plug into this other than a coffee maker(from a previous post lol) that incan test without burning it up, any ideas? Haha...
-
Scoobyshep replied to the thread MEP-114A GPU.The frequency gauge should be before the output contactor so it should indicator frequency even if the main contactor is off. I would...
-
Good Day: S12 looks good, (sometimes these do go bad so move them a couple times) but if the DCS still indicated the 3665 error, you... -
Aazreark1 replied to the thread MEP-114A GPU.Yeah i think youre right for it being an air leak source, and also correct on the location, that is from the fuel selector to the first...
-
maddawg308 reacted to deank's post in the thread What have you done to your CUCV today/lately - Part 2 with
Like.
The vacuum line goes to the VRV on the Injector pump. Lower position. This provides vacuum to the transmission modulator for shifting... -
Ethan Phillips replied to the thread TH400 slipping out of third gear.Sorry it took so long. Didnt mean to leave ya hanging. Been busy with other peojects -
Barrman replied to the thread TH400 slipping out of third gear.Thanks for posting the end result. -
deank replied to the thread What have you done to your CUCV today/lately - Part 2.The vacuum line goes to the VRV on the Injector pump. Lower position. This provides vacuum to the transmission modulator for shifting... -
UPDATE: The problem ended up being the vacuum lines and the vacuum regulator valve. Apparently the vacuum lines were backwards and the...
-
spankybear replied to the thread LMTV AC parts diagram..I am looking to modify my existing cab heater to add an evaporator. I want to see how it has been done. Most likely looking for the... -
Ethan Phillips replied to the thread TH400 slipping out of third gear.UPDATE: The problem ended up being the vacuum lines and the vacuum regulator valve. Apparently the vacuum lines were backwards and the...