-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Latest activity
What's new
BMI
Midwest Military Equipment
Eastern Surplus & Equipment Co
-
GI needed to replace my master cylinder on my 54 M37. I do have the front disc brakes. Brake bleeding has been beat to death on line in...
-
GI did check the convenience outlet and the meter didn't show any signs of voltage, ive began taking things apart to get better access...
-
GHave you tested the Exciter Stator resistance to be sure it's good? TM says it should be about 12 ohms. Have you measured the DC...
-
GYes, everything i could find to test, tested good and found no issues with the wiring, connectors fuses, relays, it was those kind of...
-
GThere is no need to externally "flash" the gen head. THE DCS takes care of doing that automatically. Excerpt from the -10 operators...
-
GHello. UPDATE.. so with all the help ive received i made progress, the Panel is active and the generator starts and sounds great, ive...
-
GGood Day: Just bare with me here. On that J2/P2 there are pins DEF and def. DEF are on the outer ring of the connector and DE go to...
-
GOk, ill do that, Im having some trouble identifying where the wires d,e,f are landed prior to the connector to check them. Im still...
-
GSupercool! Just check the Battery power to the DCS as indicated in the manual. Power there, check the pins for ground. If no power...
-
GGood Day: Below is a link to Technical manuals for your generator. Several members have tried to point you to the probable issue...
-
GYou may want to carefully verify the DCS is being provided +24 volts to the P2 plug on the back of the DCS. B+ pins should have +24...
-
GYep, your ABS light is because the data bus end resistor is fried And it cannot communicate properly… If I recall there is more than...
-
YWhat Timing, I have been reading all the tire post with the 33" upper limit for diameter but found a set of "gently used" 315/75-16" BFG...
-
RRonmar replied to the thread Gremlins afoot-1997 M1078 A0.Here this may help… If the dash arrows are flashing the front bumper signals should also be flashing. If K30 & K31 are clicking the...
-
-
RRonmar replied to the thread Ctis and ABs help please!?.Yep, your ABS light is because the data bus end resistor is fried And it cannot communicate properly… If I recall there is more than...
