Recent content by 64herald

great heater I've been using my heater for over 4 yrs and it's cold near the water on Long Island but it lights up every time. Had trouble with the ignition transformer. Almost every thing in side is available at a burner supple co. Nozzles are off the shelf. warm my shop great. Anthony

that's what I'm going to do this weekend, make me an flange with an elbow from an auto parts store.. the only thing next is to go to a lawn mower place with the other cap and see if they have something that will at least cover the whole till I come up with a gauge.. Thanks for the info on how...

on ebay (http://www.ebay.com/itm/Military-Heater-diesel-140btu-CO-Alarm-Garage-Shelter-On-Wheels-Prepper-/330854153399?pt=LH_DefaultDomain_0&hash=item4d0871bcb7) there is a picture of the fuel gauge and the exhaust elbow which bolts to the heater and then you place the long exhaust pipe on top

I just pickup a Choctow H-140 Heater that is NEW, never unpacked. It has the wheels busted off the unite, which I will reweld. as I was unpacking the unit I could not find the exhaust elbow and someone got the fuel gauge. Anyone know where I can get them??Used is ok also.

I have a mep003a...If I pull a load to feed my house on single phase 240 volt, can I switch to 3 phase and still pull single phase on L1/ L3 for my house and use L2 to feed my neighbors house with 120 volt

I finished the fuel hook up today and ran the whole house about 3 hrs. When I put it in AUX position it filled the tank to the top and was ready to over fill it, so I tapped the solenoid a few times and all is well. I drained some fuel from the tank and tried again and now I get 1/2 tank on and...

​today is the warmest it's going to be for the rest of the week so I worked on Placing it where I wanted it and wired it into the house. Next week I'll work on the oil line. Thanks for all the replies, I'll let you know when it's hooked up.o

I just got the unit in Dec with 119hrs. I did all the filters (they were all new) Did the oil batteries fuel lines, tightened all the electric connection. and started it up.. took a little priming but runs great. had the whole house running on it at less then 50 0/0. that was done on the main...

​I have an mep-003a that I hook up to an auxiliary fuel tank. I put the master switch to prime/run/aux, the pump kicks on an fulls the main tank but won't shut off when full. I disconneted the wires from the tank float with no shut off. Any ideas where to start looking? Sounds like a relay...

When they go back together should I use antiseize?