Recent content by 98BlackHMC4

Sounds good. I can agree im probably past the point of field quick Diagnosis - Ive been recommended to this J1708 / J1939 and also Cat ET - Does anyone have a suggestion in regards to which software is best? also where to source? I come from automotive, and there are many imposter...

Year later - Update Hey All - Crank No Start - Looking for some help 2000 Stewart M1088A1 7JZ01194 - Engine Serial # Previously truck ran fine Parked for a few months and returned (NO CHECK ENGINE LIGHT) upon powering up the machine Truck does not have start inhibit switch - Also...

What’s the going rate for a 6x6 set?

dang, that's not encouraging !! ha, stuff happens, hoping its not that I just went out and verified i have return fuel at the tank - so we have flow. Transmission light still illuminates on dash upon power. However, No CEL at all during attempts to start unless i do a lamp test in regards...

Hey All, Im having some issues with my 1088A1. Its run before, I've put over 100 miles on it. Replaced parts etc. Ive been through the ringer with paperwork on it and have recently been waiting months for a replacement title. Finally receive papers and go to start it with no luck. In the...

Ive considered many ways to salvage and repurpose this unit into a 3 person camper, basically 3 slots for people to sleep in, storage underneath. canvas overtop. Lack of storage space prevents these ideas. with ideas for kayaks and dirt bikes as well as the roof top tent i dont think any of...

I appreciate all replies in the matter, its kind of what i figured is the parts were of no value since they are essentially just junction points for connections to much more valuable pieces. If anyone sees anything they want, id be willing to send it out there way. Thanks again, J

Hey all, Im searching for an M1102 locally and someone Ive met along my search has one that is outfitted with some radio / communication stuff. its quite the rack system and has some stuff still outfitted to it. I guess the roof portion was removed or cut off at some point but these are the...

does anyone have the measurements for the tracer piece for the hatch? even if its something like 12" down from roof edge of hatch and 3" inwards type deal. i know there is a hole that gets drilled based off the inside of the hatch but I'm missing the stencil for the rest and dont want to just...