Recent content by barrettb

she is alive :) the starter must have been alittle stuck cause it took a few good raps with a big hammer and she fired up.

the starter will only engage when the batteries are almost dead. but by then it barley has enough power to turn the engine over. i have tried hitting the starter that didnt help much. what else could it be?

the starter will only engage when the batteries are almost dead. but by then it barley has enough power to turn the engine over. i have tried hitting the starter that didnt help much. what else could it be?

the starter will only engage when the batteries are almost dead. but by then it barley has enough power to turn the engine over. i have tried hitting the starter that didnt help much. what else could it be?

ok the starter will kick in and turn the engine but only after the batteries are out of juice so it is like the starter is spinning to quick to engage.

ok i got the hood open. and i put the charger on the batteries and charged both of them but when i try to start it i just get that clicking noise when u u have low batteries but both batteries were replaced this summer along with the that starter. so do any of you know what it might be?

the handle in the cab moves. but after that i cant get the hood to unlatch i have tryed hitting the top of the hood. but i cant get it open.

on my m1009 i can not get the hood latch to release so i cant get it open is there anyway to release the latch another way so i can open the hood??

ok i have gotten to the "c" clip. but i am having problems getting it off. is there any tips for taking them out??

the c clip is held on by 2 bolts?? if it is i already took it off but the spindle/shaft still wont come out.ami still doing something wrong??

a seal went out on my m1009. the piece that the seal when out on is the piece that the tire bolts on to that goes to the middle of the axle. and i am not sure how to take the piece out of the axle so if you could help me it would really help me.