Recent content by buick

what the going price on a goat jack with folding handle?

Have several idea's in mind but another always helps. With all the rusted tubs and windshield frames around hoping someone may have them. thanks Jerry

Door rails needed and wore out cushion sets.FOUND Need the door rails for both sides, top and bottom. These are the rails on windshield frame and body that the doors slide into. Need complete set of front cushions also. FOUND

Need a part # for the rear driveshaft U-joint at the diff. yoke. PUJ-235 NPJ-P534G are wrong numbers. Need U-joint with C clips on inside and spring clip on outside. Bearing caps are two different sizes. Smaller cap goes on driveshaft and bigger caps fit the yoke. Napa got the micrometer out...

Wanting to buy NOS gas arctic heater kit for M-38. Anyone have one or know someone who may have one for sale.? Thanks Jerry

Replaced fuel filter with a WIX element , had a Fram. Started this morning with the bump of the key. Problem solved. Thank you Recovry4X4 Jerry

That's kinda what had in the back of my mind was like the fuel was draining back ward and the lines were empty.

I've done the search for this problem in CUCV thread and no luck. Removed fuel pressure switch ,taped hole and plugged. Checked the screw for leaks and is sealed good, no drips. Ran and started fine for about a month, then starting after sitting overnight is hard to do. Any time through out...

Best way to go. get a 1/4 " tap, tap it ,place a 1/4 screw in snug and after you get the lines bled, just bump the key. WHY SPEND MONEY. Thanks kentuckycucv. Starts better than before. 1985 M1009 103.--- miles.

Wondering where my Goat I sold back in 1981 may be. Had 13 miles on it when it came out of Fort Meade in 1979.I sold it with 1300 miles on it. I put a winch on it. From all the names scratched under the hull, I located one man who said it was a training aid. It set in a bay and was the first...