Recent content by CA_LEO

Ideally that’s what I would prefer to do. But I appreciate both sides of input. I’m very thankful for the information that I won’t be SOL if I have to use a standard stud or bolt.

I found part number 12337960, however from everything I have seen, this does not have the flanged shoulder. If you have a source for the one with the flanged shoulder, I would greatly appreciate it. Like I said, my OCD gets the best of me and I would prefer to put the OEM part on there.

That’s what I was hoping to hear, but wanted to tap the knowledge source here. Thanks so much! Sometimes my OCD gets the best of me.

Thank you. The ones from Autozone will not work either unfortunately. The shorter part of the stud is 5/16 20 thread and the longer part of the stud is 5/16 18 thread. Leave it to GM to use a part as messed up as this...

I forgot to ask if I was wrong in the assumption that these appear to help center and prevent the pulley from slipping around on the water pump. If there is another type of stud or bolt that will work just as well I will gladly take those recommendations. Thanks, I can find those ones that you...

So, I’ve tried searching this forum and countless others. I’m looking for the 5/16 shouldered studs that mount onto the nose of the water pump and keep the fan pulley centered and attached to the water pump. I found a part number in the 289-34P TM, which was 14061661. Problem is this is...

Thanks @Whitfield for the Duramax filter setup. It made bleeding the system after my banks install an absolute breeze!

How’s this setup holding up for you? I think I like this one best.

Thank you kaiser, you answered my questions and thensome!

Does anybody have any suggestions for the pyrometers and boost gauge setups for this install?

I appologize for the extremely delayed response, it has been an interesting summer to say the least... I contacted all the above mentioned companies and West Texas Off Road saved the day. I must say I have never had a better customer service experience and highly recommend those great folks.

Thanks guys. I will let you know what I find out.

Could anybody give me some recommendations on where I may be able to find some parts for my steering gear box. What I am after is the thrust bearing spacer (# 20 in the picture below). And here is the reason I need a new one...

Thanks. I checked his website, doesn't appear to have much for the m1009 at this time.

My bad. It has been a while since I read the rules and thought they only applied to GL listings. Won't happen again.