Recent content by Clayshootr

You are correct. I guess that will be the next step.

I have a M931 that I recovered out of Mississippi 3 yrs ago. It has been a real good running truck up until yesterday. I hooked up to the flatbed and loaded my JD 4430 tractor up and pulled it about 100 miles (to Reb87's place). After unloading the tractor I went down the road to unhook the...

It is a diesel. I had it for the past 20 yrs. Just sold it last month to purchase a grain trailer to put behind my M931.

Farm is about 35 mi northwest of St. Paul.

I have to move my generator outside for a few weeks. Will it be ok outside in the elements?? I plan on throwing a tarp on it when I get back up to the farm next weekend. I assume they are built to withstand more than a dry Nebraska winter. Thanks for the info!

I have a M931 that came out of Camp Shelby. I was disappointed with the performance of the truck. I had it almost a year before I finally decided to take it in to the shop. It would fall flat on any kind of a hill and when in neutral the rpm's were very slow to increase when the throttle was...

I was trucking down the road the other day in my M931 to pick up a John Deere 4430 tractor that I had purchased and all of a sudden it started to stink something terrible in the cab. I looked down at the gages and noticed the alternator needle was up in the red zone. I looked under the seat...

I know I have seen it on here before but could not come up with it in the search. Need to wire up a 7 pin plug to go to my grain trailer. Thanks! Tj

I have a M931 with the 250 Cummins in it. It has warmed up on me a few times. The coolant level is up and the belts are good and tight. I did not think the fan was kicking on so I installed the two bolts to lock the clutch up so it now runs all the time but still gets hot... Just wondering...

I know my M 931 is the same way. I was bringing home seed and fertilizer the other day and I was down in first going up some of the larger hills. I spoke to several shops about my lack of power and was referred to a diesel shop that has been around for a lot of years. I spoke to them and...

So it is 1/8" pipe that will screw into the axle housing? I took the vent plug out of my 931 rear axle because of this same problem. Every time I took the check plug out the diff was pressurized, and oil is leaking out the front pinion seal.

The truck averaged a little over 5 mpg. I think we spent about $725 on fuel for the truck.

Thanks! I downloaded the -10 manual but will check out the others.

What kind of rear ends are used in these trucks? I think I need a pinion seal and not sure where to look for one. Thanks Tj

Sealed bid on GL. I bid on three of them hoping to get one. The one I didnt win had a ~ $5000 bid on it. I really liked the fact that my wife or brother can help me haul this fall because of the auto trans and low range. I am the only one with a Class A CDL.