Recent content by dskupi01

Light was dim (not fully lit). Removed connection to proportioning valve brake pressure sensor. Cleaned out water and transmission fluid from the sensor. As mentioned, I had a leak from Callilac valve hose, and used water to clean up the mess. Sensor was saturated with oil and water...

I am working through the diagnostics via the TMs and the wiring diagram on a brake warning light (on after parking brake released). I could use some help understanding the function of the pressure sensor on the proportioning valve. Precursor, I had a Cadillac valve hose leak...

Did not appear to have been signed. Will it be propoesed again? Near unanimous support, so why not?

On the governor’s desk. https://www.legislature.mi.gov/documents/2017-2018/billenrolled/Senate/pdf/2018-SNB-1040.pdf given the near unanimous support, hopefull he will sign it.

On the governor’s desk. https://www.legislature.mi.gov/documents/2017-2018/billenrolled/Senate/pdf/2018-SNB-1040.pdf

From reading the mi legislature site, now passed both house and senate and not yet reconciled. Correct? Will it be signed into law? Does this have to sign into law by year’s end, or it will restart?

Here’s what i did. Works great. Keyed (sort of). https://www.steelsoldiers.com/showthread.php?170794-M998-Battery-Shutoff-kill-switch-My-final-setup-with-pictures&highlight=

..http://www.flamingriver.com/download2.php/products/c0015/s0007?instructions sorry, i can’t provide the size. I just used a step drill. It does show instructions either. I’d just measure with calipers, but the truck is offsite for winter storage.

I will double check wire pulled, and try it again. There were two wires, next time both (although labelled). I didn’t think the plug under the alternator (i have 200amp) looked too bad, looking at it from underneath. I believe all who have already done it to know it will be tough, and report...

A bunch of questions: i need to change glow plugs. Only one is bad (hardest one under the alternator, not surprising), but cheap enough i will replace them all. 1. With the risk of breaking one on extraction and putting a chunk into the cylinder(past the pre-combustion chamber), is it worth...

There’s one edit I would recommend. Although the wix51061 oil filter funtions, it does not have the anti drain back feature (back flow preventor). The wix 51060 has this feature. I’ve found the time for the oil pressure to pump up on startup is significantly longer with the 51061 filter after...

Not sure if mentioned, i'd say trust no mileage on any hmmwv. Unlike cars, I think the military replaces speedo gauges without marking chassis.

I concur with the previous comment. Follow the overflow tube from the cap. Was this where it was leaking? System was likely slightly overfilled, expanded, then leaking down overflow tube. I've found the coolant in the system expands significantly. The syptoms you have are consistent with...

Nothing i've noticed. It does give you piece of mind any phantom current draws are gone.

https://www.steelsoldiers.com/showthread.php?165300-Humvee-Wheel-quot-winch-quot-Self-Recovery