Recent content by ewylam

Has anyone used the aluminum brazing rods that are all over facebook. I'm wondering if I could use the effectively to fill the holes left by the armor?

Well I finally got around to pulling off those extensions but the result was unexpected. I used a claw-type puller and each came off with one good pull. Unfortunately as you can see in the photos both the original and extension arms came off together. There is also a small brass washer that came...

Well, I removed the paint on the extension and verified it does not have the allen screw. They also don't appear to be pressed on because there is about 1-2mm of play on it. It's very hard to see but there may be a retaining ring holding it on. Ring any bells? Squirel - was that how yours were...

In

Nice light bar! What type is it?

Good to know the wipers will work with them on. I'll see if they come off easy and if not probably just leave them on. I'll update how my attempt to remove them goes.

Coug! Thanks for the reply. I'll try to pull them off then!

That's what I was thinking but I cannot find a set screw which threw me off.

Anyone know that this is? It's mounted to the windshield frame on the passenger side.

Can anyone confirm if this is the correct wiper arm attachment or if there is some extension installed. If it is an extension, any idea how to remove it to install the correct wipers?

I forgot to mention I got my replacement pump from the gentleman above. He was very helpful in identifying the correct replacement and the product was clean and as represented.

I had the exact issue on my 1045A2 and it ended up being a bad fuel injector pump. Mine had sat for so long the off-highway diesel had gummed everthing up. Before I fired the new injector pump I drained the fuel tank and lines and refilled with clean diesel and some fuel system cleaner. Fired...

cucvmule, I've considered fabricating some rock rails that would extend up the front fender and down to the rear wheel well reusing the holes in a similar fashion to the armor. I may still go that route but wanted to consider other options and was also concerned with the piano hinge holes...

Hey all... another request for your valuable insight. My 1045A2 came with the turret delete bolted on and it looks like they replace the B and C pillars with a splice. I don't foresee adding a turret so I want to keep the patch in place. Considering the splice pillars I'm concerned with the top...

Thanks for the replies! I'm going to try the plugs and bolts to see which looks better. As you can see from the pics whoever removed the armor wasn't very gentle so some of the holes need attention to smooth out. I'll post picks when I'm done.