Recent content by FFesco

I’m having the same exact issue. May just get a new caliper, I did read somewhere on these forums of a cheaper alternative like American eagle vehicle, something along those lines

Wow looks great! Sent from my iPhone using Tapatalk

Fabricating a center console for my m998 Check my Instagram out for a time lapse video Instagram: FranMar.NYC Sent from my iPhone using Tapatalk

Tough crowd, but I appreciate the feedback. Definitely makes sense as to why I shouldnt have it in. And yes I was bored, always trying to figure out what I can do to make my rigs unique. Sent from my iPhone using Tapatalk

I’m in! Sent from my iPhone using Tapatalk

installed this deflector for the front grill. 100% aluminum Sent from my iPhone using Tapatalk

Put on a new soft top, Nitto Ridge Grappler tires and rims Sent from my iPhone using Tapatalk

It’s definitely noticeable, more so when I put it on the back side of the doghouse! I plan on putting down a piece of plywood on top of it as well as a center console that will also be insulated. Definitely recommend the Dynamat! Sent from my iPhone using Tapatalk

None whatsoever, I would recommend buying the good stuff, Dynamat, conforms very easily. I did use a handheld torch to help “fuse” it once I was finished. Sent from my iPhone using Tapatalk

Added some dynomat sound deadener. Going to make a center console out of wood or fiberglass. Sent from my iPhone using Tapatalk

Changed my brake fluid, DOT4, on my m998. The fluid keeps changing colors. Sometimes has a tint of red, sometimes a tint of blue green. I’m guessing the red is old rust, not sure about the BLUE. Any ideas? Sent from my iPhone using Tapatalk

New to using forums as well as not very good with automotive electronics! I’ve searched a few lights that will fit the way I want, but trying to understand the wiring. Basically, can’t I cut the stock wire connector (rubber boot) and just solder it together or should I do it another way...

Has anyone used any of the aftermarket LED lights sold online? Any recommendations? How about wiring? Sent from my iPhone using Tapatalk

Dropped the gas tank because I was losing pressure and had a leak. Replaced the lines and clamps, tank was pretty clean overall. Replaced the fuel pump ($40) as well and brand new starter ($450 ouch!). While up on the lift, found out the inner/outer tie rod on front right is shot. Any...

It’s difficult to give you a number without seeing your truck. Plus, I’d like to do it here at my shop so that it’s done right. Sent from my iPhone using Tapatalk