Recent content by Fmeroney

Deoxit came tonight so I’m gonna hit it tomorrow! Sent from my iPhone using Tapatalk

Will do, got the parts on order and will not fire it up till I have that in. Sent from my iPhone using Tapatalk

I’ll give it a go! Sent from my iPhone using Tapatalk

I remember, fixed the leak but haven’t been able to locate the source of the over voltage issue... Sent from my iPhone using Tapatalk

Thanks for this, looks like my machine needs the fuse installed. I ordered the parts, do you think this could be linked to my issue? Sent from my iPhone using Tapatalk

Hi Guy, I’m not sure What a Quad MWO or MOV are... can you elaborate? Thanks, Frank Sent from my iPhone using Tapatalk

I do have all the TMs for the 804, and I will give that a try and see what happens. Sent from my iPhone using Tapatalk

Hey all, I did a voltage check today after a routine startup and noticed that it’s was producing 132v so I tried to turn it down, as i turned it down the voltage spiked to 170+ volts and the unit shut of. I then attempted to do the same on restart but got the same results. Can someone point me...

Thanks, I already have all the TMs Sent from my iPhone using Tapatalk

Hello all, I have a question about the startup switch positions and want to clear up what they do. There are 5 positions - Preheat, Off, Prime & Run Aux, Prime & Run, and Start 1. Preheat - Preheats glow plugs, Is this required or for cold starts. 2. Off - Off, No explanation needed 3. Prime...

Hi all, does anyone know how much current is passed through the S1 switch? Sent from my iPhone using Tapatalk

Can this be used on an 804a??? Please say yes!! Sent from my iPhone using Tapatalk

That’s good to hear! What does it cost to clean it? Sent from my iPhone using Tapatalk

Hey all, I may need a radiator for my MEP 804a. I pulled it out today and there is definitely a leak. there seems to be a fair bit of corrosion inside so I’m not sure if it’s salvageable, but I will bring it to a repair shop to see what they say. However, just in case it’s junk, I have been...

Got ya, thx guys