• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Recent content by Gcelevator

  1. Gcelevator

    Polaris MRZR-D4

    Replaced the starter last week as it went bad, tatally diferent now. The part i bought was rarelecreical prior to oulling the part out and it fits perfectly. The original starter is a Bosch 1005 821194 RAREELECTRICAL New Starter Motor Compatible with Kohler Marine Application with Ldw 1003...
  2. Gcelevator

    What have you done to your HMMWV today/lately

    I was planning to make the closeout plate out of 1/2 aluminum plate i have.
  3. Gcelevator

    What have you done to your HMMWV today/lately

    Thanks.
  4. Gcelevator

    '89 M998 poping when accelerating in a straight line.. diff?

    Pillow bearing in the front drive shaft?
  5. Gcelevator

    What have you done to your HMMWV today/lately

    You printed it or bought it? Link?
  6. Gcelevator

    What have you done to your HMMWV today/lately

    I might keep using electric. Did yoy remove mechanical at all and put a closeout plate in the place?
  7. Gcelevator

    What have you done to your HMMWV today/lately

    Agreed and noted. I am planning on going mechanical again and just leaving the electrical as back up where i just have to switch hoses and re-install the fuse to get back on the road if i get stranded. Well not sure what i am going to do yet to be honest, was just too lazy and it was too hot to...
  8. Gcelevator

    What have you done to your HMMWV today/lately

    This one. Installation was fast as i did not remove the lift pump yet. I am going through all the plumbing of the existing. I wanted to test 1st prior to the rmoval of the mechanical. Installed on top, right next to the power steering reservoir and used a switched wire from the instrument panel...
  9. Gcelevator

    What have you done to your HMMWV today/lately

    The lift mechanical pump on the 1123 left me kind of stranded last week. Installed a Facet electric pump 4-6PSI and has been testing fine so far. Bought a new mechanical pump from HPG but will not install in the near future and when I do, i will leave the electric one in place for emergencies...
  10. Gcelevator

    Polaris MRZR-D4

    Yes, i believe it is ATI, the original manufacturer of the molle top. You have to call them to order. Mine are already rotten again, and the cost was like $1,600
  11. Gcelevator

    Polaris MRZR-D4

    Hi @publicenema. Do you still have access to the part numbers? I am looking for the engine starter part number, if you could help. There are many variants of the kohler engine. Thanks.
  12. Gcelevator

    New HMMWV Owner In Oregon

    Around a year ago (or so) when i bought the last truck, they were offering the FL title. Fair enough for me i opted for it and later down the road either i called them asking about it or they called me (i don't recall) they apologized and refunded the tittle money as they could not issue the FL...
  13. Gcelevator

    New HMMWV Owner In Oregon

    The duplicate number also happened to me on 3 vehicles. In my case they just had to call the state of FL DMV and issue the same duplicate number with a note. One time was a boat, another time was a trailer and last time was some kind of small european antique car. So, she explained to me, once...
  14. Gcelevator

    New HMMWV Owner In Oregon

    Yoy You won't get a Florida title from Gov planet. They just don't do it.
  15. Gcelevator

    OUT AND ABOUT WITH MY HMMWV

    ja, interesting. it has been a couple of months i don't drive it everyday but before i used to. use to go a lot to McDonald hardware. we have to get together sometime.
Top