Recent content by gump65

Of course

Thanks Yes you are correct, I was referencing the -24P variant. ….pay attention to the details, a wise man told me once…. obviously I needed to told at least twice!

My down load for TM 9-6115-642-24 only goes to page 152. I must have a corrupt file or something, but it was a direct download from SS. Things that make you go hmmmm!

I copy/pasted all the links into my own folder. As I need them, copy/paste into my browser... voila! But really do appreciate all the work done to organize all the info... INCREDIBLE!!!!

Thanks Will do that.

Found the torque numbers for the Flywheel TM 9-2815-253-24, Table E-1, Flywheel Bolts 50.1,51.3, 52.5 Ft/lbs Haven't found the torque values for -drive plate to flywheel and -rotor to drive plate Is there a chart for these values? In the end I won the battle with removal of the fuel/water...

Moving on, Found the torque numbers for the Flywheel TM 9-2815-253-24, Table E-1, Flywheel Bolts 50.1,51.3, 52.5 Haven't found the torque values for drive plate to flywheel and rotor to drive plate numbers. Is anyone able to point me in the right direction? In the end I won the battle with...

Lucky my MIG is out of wire....

Thanks DG for the information. Will certainly find out about how to ensure the support bearing is located correctly to a longitudinal dimension.

I did have in mind what you suggested but all seemed to be seated as they should when removed. In preperation for reassembly I have wired wheeled all mating surfaces to remove any spots that might give me some grief.

Ok, there was more then a minor crack in the drive disk..... . Guy, the info you listed in the -24P TM is perfect. I am hoping to take the bearings into a local Bearing supplier and source an equivalent there. As long as they aren't proprietary, things should work out. I am hoping the back...

I will compare bearing cat #'s on the 2 rotor assemblies that I have. Hopefully they are a different number. Guyfang, any idea of the replacement bearing number? Where would I search to get such a number?.......

Hello all! Recently new here on SS with my first purchase and have started into a remove and replacement of the genhead on an 803A- it was known to be bad at time of purchase. LID supplied me with all of the parts I need to be successful in my work - Shout out to LID! I have been documenting...

jwhite, I am also new here on SS site with a generator purchase. Recently picked up an 803A and a replacement genhead from Light in Dark. He had done all the trouble shooting/diagnosing on the unit and determined the problems. It is now up to me to do all the leg work and make it purr again. I...

I am just in the middle of an 803 purchase from L.I.D. Seems all good recomendations lead back to him!!