Recent content by ICAT

  1. ICAT

    Another brake issue

    the pedal stopped 2" from the floor when i was bleeding the brakes. i have good pedal but i can stand on the pedal and it takes along time to stop. That why I was thinking major/minor adjustment.
  2. ICAT

    Another brake issue

    Ok, 1988 M35A2, dual brake system. First, Rebuild both air packs because i had brake fluid blowing out the vent tube. After rebuild, bleed brakes. When i bled rear brakes, pedal goes to the floor, when I bled the front brakes, pedal stops about 2" from floor. I'm doing the the 2 person method of...
  3. ICAT

    MEP105A Gen Starts and dies

    Gen is running great. It just started leaking out of the final fuel filter. Looks like i need to get a filter kit with new gaskets.
  4. ICAT

    MEP105A Gen Starts and dies

    Ok, so here is the deal. The injector pump needed to be rebuilt. got it done. After reassembly a slight distortion in one of the injector line washer caused a leak. Also there is a dead crank switch which allows you to crank the engine without it starting. Well don't trust the label. the switch...
  5. ICAT

    MEP105A Gen Starts and dies

    starts run and dies
  6. ICAT

    MEP105A Gen Starts and dies

    I had to remove the injector pump to a shop for a rebuild.
  7. ICAT

    MEP105A Gen Starts and dies

    it was purchased from a federal surplus as a emergency generator. We have had it installed for a year. This is the first problem we have had so we are pleased with it
  8. ICAT

    MEP105A Gen Starts and dies

    Found it. It was the check valve on top of the injector pump. Took off the t-fitting on top of the injector pump and it started right up. Shot fuel everywhere but it started and ran. So I took it back to my shop and empty a can of brake cleaner on it and the ball started to move. There was a lot...
  9. ICAT

    MEP105A Gen Starts and dies

    MEP105A is a 60k generator
  10. ICAT

    MEP105A Gen Starts and dies

    it shuts off like it was turned off
  11. ICAT

    MEP105A Gen Starts and dies

    I work for a small municipality and we have a generator that just starts and dies. Fuel filters have been changed. Speed switch and oil pressure switch have been checked according to the -12 manual. Any help would be great.
  12. ICAT

    11r22.5

    i think it steers easer and less bouncing when driving on the hardball
  13. ICAT

    11r22.5

    here you go
  14. ICAT

    11r22.5

    I'll get some pics uploaded today
  15. ICAT

    11r22.5

    i did it to mine and i love it
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks