Recent content by klugpi

The problems I have experience on the air system on my am 923 A2 1991 are the air dryer the regulator the PPV ( pressure protection valve be the pressure protection valve) which is located primary tank that doesn't allow air out of primary tank to the auxiliary tanks unless it has so many...

The problems I have experience on the air system on my am 923 A2 1991 are the air dryer the regulator the PPV ( pressure protection valve be the pressure protection valve) which is located primary tank that doesn't allow air out of primary tank to the auxiliary tanks unless it has so many...

I have an air compressor problems for sometime, finally took the head off the compressor last night it's all ______ up,here some rebuild kit information for my compressor my compressor is a HOLSET number 3558006 - SS296. Cummins west does not carry any rebuild kits for this compressor don't...

Ol there is a tin cover over the casting that holds the seal.

I now took the rear out put / pinion 21/4" nut off and got the shaft out the front, but the input housing is still stuck to the bearings. I could not even press the shaft through. The input / pinion seal has to come out from the inside of the housing. Is there something that I have missed...

Does anyone in the Bay Area need any thing heavy hauled from The Military Guys to SF Bay Area! I'm leaving to night coming back tomorrow!

My M923A2 is registered as a historical Vehicle, but has only lap belt on passengers seat, no back up alarm, no back up lights. I 'm driving it down on the 8th and hope they let me dive it for the DMV test! Hope we get to go through some water!

I would like to pull a disk or other implement with hydraulics, If I add more hydraulic control levers could I use the winch hydraulic system to run say a disk?

I'm installing an entire winch PTO and hydraulic system on the M923A2 Ihave the PTO installed the backlash is set at about 8 thousands!

I'm looking for a M923A2 fuel cap flat rubber O ring & the Rubber O ring on the neck I have fuel leaking out when I drive my 1991 M923A2, it leaks around the fuel cap and the fuel tank neck area. there are rubber O ring on the cap and on the brass fuel tank neck. Anyone know where to get...

Thanks For the good ideas. And I will not use the Harbor Freight $2 fitting.

Has anyone put a quick connect air hose on there air tank? If so what tank should I put it on? Does it matter what air tank I install it on?