Recent content by kooldadd

Accurate diesel. Downtown orlando. Sent from my SPH-L720T using Tapatalk

I plan on cleaning it up first... just aggravating when you think it's good to go and........ What really sucks is, I got it tagged today.

I'm learning that quickly

Little bit of oil looking down on harmonic balancer on the front cover. Lower is bad. Oil pan is covered and front end will never rust.

Previous owner had 5 gallons of oil stuffed in the storage box on driver side... looks fishy to me

Well, POOP!! Drove around the block and noticed the oil pressure was around 10 at idle when I stopped. Looked under truck and oil everywhere. Checked the dipstick. .. no bueno! How hard is front seal to change?

10-4 thanks

Everything gone through... good to go. I did use just under a gallon on mine just to make sure everything was flushed out good. Shouldn't need that much to rebleed after air pack install

https://m.facebook.com/MidwestJeepWillys/ ordered air pack Monday. 459.95 SHIPPED! Should have it Friday. Cheapest I found.

I was only asking if air in the lines would keep the air pack from working so I could order one, if need be. The only thing I would be saving money on would be the fluid, because I would have to rebleed the system after replacement. I plan on in flushing the entire system when im sure its all...

If the brake lines have air, will that keep the air valve from opening? I have a really soft pedal that doesn't pump up hard. I know there's air in there, but I don't want to waste money on fluid if it's not going to do anything.

But, yes, it will be tagged and driven. I'll be putting my 85 wagoneer in the bed and trailering one of my commandos behind it for trips to the woods and camping. Main reason for getting the deuce was because I have 4 jeeps to move around. 97 wrangler is tagged and driven, but if I break...

False joy on the air pack. Not working. Found one for 409. Need it going by next weekend, so I don't have time to try a rebuild and scramble for a unit if rebuild doesn't work.

WOOHOO!!!!!!! went ace and got a 55 cent spring... installed in fuel delivery valve STARTS ON IT'S OWN NOW. That put me at 2k for the truck, 1.02 for the hh clip, 45.00 for the overflow tee I probably didn't need, and 55 cents for the spring. I'm into this truck for 2046.57. Tagging it monday...

Correct. I did not get the spring. From what I understand, the spring is sized for length and tension when calibrating the hh when building and testing. I could be wrong, but , I would need the length on the old spring. I have part of it that I could match up for tension and diameter. Now...