-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
LuckeyD's latest activity
-
LLuckeyD replied to the thread New to me MEP-803a.Great! I recommend keeping loads under 50A per phase as the main gen is good for just over 100 AMPS total and you split it using 2...
-
LLuckeyD replied to the thread MEP-1050 Fault Code 3665.Good Day: S12 looks good, (sometimes these do go bad so move them a couple times) but if the DCS still indicated the 3665 error, you...
-
LLuckeyD replied to the thread Mag Pickup repairs on my MEP804 a.Well, you can try the procedures starting on page 2-306 and ending on page 2-307 and hopefully that one turn will clear the flywheel...
-
LLuckeyD replied to the thread MEP 803a governor question.I read each reply and one member touched on something. In post '13 you state the pumps are new and after a bad experience installing...
-
LLuckeyD replied to the thread MEP 803a governor question.Good Day: You know they are OK if you can run the gen at about a full load. If the pump tangs are free individually, check the rack...
-
LLuckeyD replied to the thread Drash/ HDT Fun.Good Day: Tent stuff is also in the manuals for the system. I attached manuals the TM used to derived from. Hope it helps. On the...
-
LLuckeyD replied to the thread Mag Pickup repairs on my MEP804 a.Good Day: The TM says install till it bottoms on the toothed flywheel with the tip usually between 2 teeth and back out till you get...
-
LLuckeyD replied to the thread silly humans capacity question...Good Day: I remember 151s set up with a roll bar looking thing so the CG could stand while passing troops, with cushions on those rear...
-
LLuckeyD replied to the thread MEP 803a governor question.Good Day: Try this; Pick a pump to play with. Pull it leaving everything else alone. Once in your hand, I usually put the spring end...
-
LLuckeyD replied to the thread DRASH Hose ducts and covers.Good Day: I attached a paper that may come in handy in the future as a quick reference. Those hoses are different than the heater...
-
LLuckeyD replied to the thread MEP-1050 Fault Code 3665.The actual use was a Power Plant (called MicroGrids) that would use multiple gen sets in stand by and start one when required and put it...
-
LLuckeyD replied to the thread Mep-831a won’t crank.Good day: Attached is a color coded schematic. Try these steps...(what does the SGT say; supervisor; LAR) I am a retired P&E LAR...
-
LLuckeyD replied to the thread How to wire a power panel right to my mep 803a generator.Sir: Seems you get a lot of responses. Overwhelming so Ill be short in my war and peace. operators manual says L1 to L3 is your...
-
LLuckeyD replied to the thread MEP 007B fuel pump issues.Please read the manuals. Here is one thing I reported up the chain in about 2004. A unit had 007Bs that over revved, and others that...
-
LLuckeyD replied to the thread MEP-1050 Fault Code 3665.Oh. there is a light sequence of all those LEDs inside the DCS. You need a darker room to see all of them.