Recent content by Mattell

Inside pic of the 806. Reset in 2012 Sent from my Pixel 3 XL using Tapatalk

Quad mwo Hello folks. Both machines have the large bus fuse. The fuse was missing on the 806 when I did my start up on it. I put one in from another 806 I have. Machine powered the building during start up and blew. With a good fuse it only makes power when start switch held to far clockwise...

Maybe on the percentage. The machine only had 4 hours on it. Wanted her to brake in smooth. I have had luck with sea foam on 600-700 hour machines cleaning up. This one had a new Melton unit, looked brand new... Sent from my Pixel 3 XL using Tapatalk

On the 8004 I have run 20 gallons of fuel with sea foam. No luck Sent from my Pixel 3 XL using Tapatalk

Thanks guys for the follow up. All the generators I have purchase have been completely empty, bone dry. New oil and fuel filters and fluids, even though it felt like I was thinking new stuff out. Sourced everything from Napa and used rotella t. Once filled I ran them to reach temps and circulate...

The 806 I start normally, hold the switch until I get oil pressure and see the dials indicate power. 5 seconds maybe to the release run position. That's when I notice upon releasing the switch that the power dropped off. While still running if I turn clock wise to the start position again the...

I had the 804 under a full load for a short period a couple months ago ran clean did a work in the shop. Week later started ok, then started missing when I put under a load, 40% I think it started chugging. Lots of black smoke. Sent from my Pixel 3 XL using Tapatalk

The specs. 2002 Fremont mep-804a nsn 6115013199033. The other is a 1995 Libby Corp meo-806a skid unit. Both machines are full reset under 20 hours each. I think they're unit was decommissioned and just sat around for years. Sent from my Pixel 3 XL using Tapatalk

Thanks folks for the assistance. When I got the 804 it ran poorly. I found a dry rotted split fuel line. I replace and primed the system. Ran well with some sporadic short term chugging for an hour or so while I had the coolant circulate. I had it connected to a small load, several lights on in...

I am located in the mid Hudson valley, I own several military generators. I am looking for a technician. I have a mep806 that makes power while the start/run switch is turned all the way clock wise. Once released to the run spot it no longer makes power. 2nd I have a Mep804 that seams to have a...

Hi Folks I am looking to have a MEP-003a on a trailer shipped from Fort Carson CO to Highland NY 12528. I put on uship and asked my normal shipper for a number. Is any one headed out that way and back. Regards, Mattell

Thank you. Flu. Yuk hope she gets over soon with how cold it is. I will call her shortly.

Ok.

Thanks for the offer, I hope to have found a guy with a 30 foot flatbed and winch this evening. I tried calling Drum the last few days, all I get is a machine. Are they closed due to weather? Getting concerned about the 10 day rule. The guy can pick up Thursday morning. If it falls thru I maybe...

Hi Folks Any one picking up at Ft Drum this week and have trailer space? I have 2 M1102's with tarps to move, one 60k on a skid and a 10k on a trailer. I am calling around trying to avoid multiple trips in the truck.LOL. Regards, Mattell