Recent content by mike634

  1. mike634

    Voltmeter click?

    Check the glow plug solenoid under the hood bolted to the fire wall
  2. mike634

    What have you done to your CUCV today/lately - Part 2

    Hold down for the bottle jack
  3. mike634

    Brushguard dimensions

    .25 inch think and 1 5/8th wide
  4. mike634

    Buying New Injectors. Delphi or Bosch?

    They are fine thread.
  5. mike634

    Stuck Brake Drum

    After a lot of pulling and prying it's off. CUCVRUS was right. Whatever it takes is the best way to get it off.
  6. mike634

    Stuck Brake Drum

    Have not had a chance to get back to fighting with it. I did pop the nail heads with no luck. The wheel cylinders are not more than 2 years old. I did open the bleeder and removed the brake line. I might try a hydraulic spreader to force it off if I can borrow one from work for the day.
  7. mike634

    Stuck Brake Drum

    My right side brake drum on my M1028 has gotten the best of me. Axle shaft is out and the locking ring is removed. E brake is off. The wheel would not move by hand when I started on it. The adjuster is frozen and I am letting it soak overnight in PB blast. I was able to work it where I can...
  8. mike634

    What have you done to your CUCV today/lately - Part 2

    That is a homemade bracket. I am not sure if you have a direct drive or gear reduction starter. They use different brackets.
  9. mike634

    Mystery wire near heater switch on m1009 ???

    The volt meter socket bulb should be a 1445
  10. mike634

    What have you done to your CUCV today/lately - Part 2

    Getting closer to being back on the road.
  11. mike634

    6.2L fuel leak

    Small hose running from injector to injector could be leaking if they are cracking.
  12. mike634

    What have you done to your CUCV today/lately - Part 2

    Got to work doing some frame repairs and knocking the rust off the frame. After a coat of KBS coating it should be back on the road. Also found my welding skills are not what the used to be.
  13. mike634

    1009 hood cable came loose or broke

    I just went through this with my 1028. The cable snapped about a foot from the latch. I unbolted the handle under the dash then I was able to lift the left side of the hood and snag the cable and pull out a few inches from under the hood. After cutting the cable I grabbed the inner cable with...
  14. mike634

    April 27 & 28, 2019: MTA Military Vehicle Show & Swap Meet (Augusta, NJ)

    I have a m1009 rear bumper for sale if anyone needs one. I can stop by the show at any time.
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks