Recent content by Mkestamper

Update on the mep-1040. Ordered part from PG Engineered Control Solutions. Installed new governor today, and all os well. The folks at PG were very helpful, and went the extra mile to make sure I was getting the right one. Part was pricey! Part is of original quality and not oozing...

On the Part itself is a CAG Code 5DR61 (DQ) below that is a PNR 30554-SCNO-04-21855. Is a CAG same as a CAGE?

No, I have not. But I am liking your way of thinking. Thanks for the info

Thanks guys for the info, and support. I will post back my findings.

Resistance information

I appreciate the advice. I did come across in the TM about what the resistance should be. Mine is open. The numbers are a little worn.

A resource for a new governor solenoid.

You are right, it was 2967. I have no Idea what Digital Control System it is running. It was mfd on 04/2013. Had 5hrs on it when purchased from GP auction. I did ohm out the the governor solenoid, and it is open.

So.....Mep-1040 would not start today. Gave me a governor fault code 2965. I haven't dug to far into it yet, but was hunting the web for a replacement and is not looking good. My meter is loaned out at the moment, so I haven't tested ohms or voltage to the governor solenoid yet. If any of...