Recent content by pat356jones

  1. P

    Unimog FLU419 Cylinder Seal Kit

    Thanks. I've looked all through that section but could not find it. It's the short cylinder that sits vertical in the attached photo and it locks the outrigger in place. I know it's not seal kit part number 1543273C1 because I ordered that one on the advice of someone else and it looks like...
  2. P

    Unimog FLU419 Cylinder Seal Kit

    I don't know if this is the right place to post this but I'm looking for a part number for the seal kit for the small (8" approximate) cylinder that locks the outrigger on the passenger side of a FLU 419 Unimog. It sits vertical at the rear of the vehicle. I've looked through the Expedition...
  3. P

    Unimog Won't Go

    I'm not sure but I think so. It was a part that was difficult to access under the passenger seat area. At first we thought we might need to cut a hand hole under the seat and cover it with a plate but my mechanic friend was able to access it without doing this. All I know is that he fixed it...
  4. P

    Unimog Won't Go

    It's back running great again, going over 50mph and I'm using it like crazy. I dug a septic system lthis week and used it to place 16 foot long concrete lintels on the 18th course of a CMU barn I'm building.
  5. P

    Unimog Won't Go

    Yes, it had something to do with the air system on the shifter.
  6. P

    Unimog Won't Go

    Thanks! That's what I thought too and that's what we're going to troubleshoot next week.
  7. P

    Unimog Won't Go

    I have a Unimog FLU-419 and yesterday I moved it a couple hundred yards to do some work and it went forward fine. When I went to back up it would not go backwards. I put it in reverse as I always have but it would not move. I then put it in forward gear and it would not move forward either...
  8. P

    Unimog FLU 419 Spare Wheel Bolt

    Anyone know where I can find a bolt that holds the spare wheel onto the Unimog FLU 419? I lost mine in a tire swap.
  9. P

    FLU-419 assistance needed

    Thanks!
  10. P

    FLU-419 assistance needed

    Thanks! I assume there is a way to tighten the belt. right?
  11. P

    FLU-419 assistance needed

    Sorry for asking here but I'm a new Unimog FLU419 owner and I'm new to this website and don't see how to post a new question. Can anyone tell me how to check the power steering fluid in a FLU419? Mine screeches a little when you turn the steering wheel. And I don't know how to check the oil...
  12. P

    Unimog FLU419 Hydraulic Cylinder

    I have a slight leak in the rear driver's side hydraulic cylinder. I got a quote of $400 to $500 to repair it with a 6 month warranty. That seemed a bit high to me. Should I repair it or replace it? If replace, where can I find one? Used is fine as long as it's a good one that works with no...
  13. P

    Flu 419 Lost all gears in intersection

    Wow i just got a 1990 FLU419 2 days before you got yours (Tuesday) so I'm not much help but if it makes you feel any better I got mine stuck in the mud today. I pulled it completely around 180 degrees with the backhoe but the front wheels were so bogged down turning the Unimog around made the...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks