Recent content by reboot

thanks for tip . going to take top and see whats going on.

mep-802a generator fuel injector leaking around head . It starts and runs. hold down seems tight. any ideas

Got clamp on amp meter ordered ,to be here to morrow. I would say i have maybe 20' #4 electrical cable from gen to house.When you say booster pump is that to boost pressure? Be good idea if some how it was able to take some of the load away from well pump Also a few months ago i was having long...

well pump is going on 35 years. going to replace it couple weeks, hoped to find a 1/2hp motor that draws less current.so you are saying your pump draws 10 surge amps ? my generator will make 26 amps on 120-240 setting.

burners were staying hot ,amp gauge was just jumping around

generator was puffing a little black smoke,amp meter would go up each time my wife would the burners a little higher,then drop back to 25% amp meter was on higher side of scale when overload kicked out. I'm going to get a clamp on amp meter check it that way. note runs 120 volt stuff great just...

Well today i hook up gen turn off every thing but 220 volt electric stove . had all top burners on high . generator kicked out on overload. also amp gauge would not hold steady keep dropping back to 25%

Have a mep-802a does not want to start well pump 220 volt 1/2 hp 200 foot depth .stops generator cold any ideas

120/240v 1ph runs good on stuff that is 120 volt just not getting 220volt between l1 and l3

Any body got a idea why my generator gets 120volts to ground on each leg but 0 volt between legs should be 240