Recent content by REDWOLF

I will take two when you get them made Sent from my SM-G960U using Tapatalk

I need one parking break handle. Sent from my SM-G960U using Tapatalk

Does anyone have a good source for parts for these trailers in the northeast Maryland area. Looking for brake parts and hitch parts. Sent from my SM-G960U using Tapatalk

Anyone have the dormans numbers handy in case I decide to go that rout. Sent from my SM-G960U using Tapatalk

Does anyone have a good resource for replacement lines. I know I can have my local hydraulic line guy build me a new set but, I would have to pull my old set of and let them build me a new set using them. My M1009 is my daily driver so I can't have it down, but my lines are weeping really bad...

Ok started working on the brake line this morning going to have to get the rubber line that runs down to the rear and replace it as well. The connection between the steel and the rubber hose is so rusted that the line wrench is either to loos or to small. I can get a 10 mm open end wrench on it...

Ok started working on the brake line this morning going to have to get the rubber line that runs down to the rear and replace it as well. The connection between the steel and the rubber hose is so rusted that the line wrench is either to loos or to small. I can get a 10 mm open end wrench on it...

The steel brake line that runs down the frame to the rear brakes sprung a leak right were it is clamped over the axel in the frame rail. just need to verify that the size is 1/4 inch so I can pick up a piece of line and get it fixed tomorrow. another real quick question does any one have a trick...

Anyone know what this blue wire with plug goes to, went to check the oil and noticed this laying were you see it.

Trying to find the camo paint pattern for my M101A2. Have been looking on here to find one that I can print out.

Found it finally on here. LOL

Looking for the paint pattern to camo my M1009. I had them printed out at one time but can not find them. I have been looking on here for the page but can not find it. little help please. Thanks

I have been looking for two antenna brackets for my M1009. I haven't had any luck locating them to buy so was thinking about making them, could anyone get me some measurements? I have pics just need some measurements. thanks

Thanks cucvrus I pulled the bezel again hoping I could fix my volt gauge at the same time, no luck with that. I did get the switch installed. But looking at the old switch it was burnt on the high position, think this may have messed up the harness a bit that plugs onto the switch had to push...

I had the bezel off the other day to try and fix my dash lights, have to pull the entire gauge cluster out to fix them. The fan switch just came in tonight. I was able to unplug the harness from the switch and get the knob off, but can not figure out how to get the switch out. Sent from my...