Recent content by remote6

Should work just fine just need the turbo right exhaust manifold turbo and intake. Let me know if you need any help. Also need customer cross over pipe and make a waste gate. Good luck.

You can just turn up your pump YouTube it

You use a crossover pipe like stated above I had to have mine made. And the 6.5 intake bolts right up to the 6.2 heads. You have to put a electronic fuel pump on the truck.

I used a Mr gasket from advanced auto. Not too expensive and easy to install.

No clear was going to but haven't had any problems so I don't know if I will

Yeah man get yourself over to Hobbie lobby that is where i got the construction paper that had grid squares already on it and just start cutting out some random patterns make a few stencils so you don't have a repeating pattern turn them upside down left and right so it's more random. Tape off...

For my M1009 I made one up but it was hitting the front drive shaft so I just had a muffler shop make one for me they went all the way around the transfer case and back up, works good cost 200$

Your front drive shaft dose not hit it? Do you have a lift. Do you have a pic

GM 8 I think

Need some pics/ideas on how people that have put a turbo on how you did your crossover pipe. Mine is all set and running but the crossover pipe hits the front drive shaft so I took it off for now but I want to do some wheeling. I dont have money for a lift now so woundering if there is another...

Taking off the inner and outer fender is a must!! Its still a pain in the ass. biggest problem I ran into was putting those exhaust manifold bolts in on the passenger side, the frame is in the way. I was not able to torque those bolts down properly no way to get a torque wench in there. Anyhow I...

I like this idea what would you do about the back? Making a door like a hard top Humvee? or solid?

So my gear reduction box on my M1009 is toast, went to a dealer to try and find one. Does anyone know what the part number is or the ratio is the dealer found 3 choices .9444 code (w), .9744 code (d) or 1.3000 code (BH)

So heres a pic of one of the stencils I made and the one side half done. Was busy with the rear main seal.

Ill try to post a pic monday work and drill all weekend.