Recent content by ribs1

I think so. Not totally sure. I took the float out and tested it's function while my wife started the gen. After that I was sure the float was ok. Reinstalled the float and made sure it seemed to have good clearance. Now all is good.

It looks like I just had the float improperly adjusted. I think everything is working now. I'll be testing now. Thanks for all the help

Just went out a tried again. No fuel light comes on. My guess is I have another bad dual float switch?

Ok, Looks like I'm back to the drawing board. I installed new dual float switch and now I have a new problem. It's not tripping the breaker anymore. When set to prime and run, it stops after a few seconds. When I set it to start, it turns over, does not start than is unresponsive. If I set...

Maybe we need to figure out a way to repair or rebuild them.

As I have been working on this I realized the original floats are foam and the new one has polymer floats. Why anyone would design a foam float to sit in diesel fuel for years, I don't know. Hopefully this one lasts forever.

Do you have one for sale?

Hello, I just did this. With s1 in prime + Aux it works fine with aux pump unplugged and aux pump plugged in. Do I need to replace the double float aux fuel sensor? Can it be taken out and repaired? Thanks

OK, So, generator runs fine on main tank. When I set it to aux fuel it sometimes runs for a while then trips cb1 After this it will throw the breaker as soon as I turn the main switch to aux prime and run. Pump runs for about 2-3 seconds the circuit breaker trips. Thanks for any tips

Thanks for the help. Going out of town for a few days, but will try again on Monday

OK, Whenever I set the generator to aux fuel it runs for about 2 seconds then trips the breaker. House tank works fine. My theory is that the pump is gummed up maybe from the leftover sesame seed oil in my drum? Any other ideas?

I did a lot of testing of my unit last summer, running the house on it etc. I wish I had setup my aux fuel situation then too. It's much better to do all your testing in the summer than in the middle of the winter during a windy ice storm. It's fun running this thing though.

Thanks for the help fellas. Another question, the drum I bought had sesame seed oil in it. I don't plan to clean it, just add diesel and go. Is this a bad idea? I figured the miniscule amount of sesame seed oil wouldn't hurt anything.

Hello, Power has been out for 6 days now. I got tired of filling the tank so I went out and got a barrel. I have the military dip tube and have it hooked up. I'm about to go out and get some fuel. Do I need to open the small cap to vent? Or does the military auxiliary tube have some kind of...

Thanks