Recent content by roadwarrior

91w350-The guage was in the green, didn't notice any change WSU-Thats what I was wanting to hear! I'll check it in the morning after it bleeds off, thanks.

Yep, it was on "0".

I haven't started up the Deuce in a couple weeks, so I decided to warm it up since its been kinda cold lately. When I flipped the power switch, the low air buzzer didn't sound. It has always sounded off before. The truck was a little slow starting, but started fine. The batteries seemed ok...

Count me in on this, I'm only 30 miles away! :beer:

I saw that giant skateboard on Interstate 44, near Vinita, Oklahoma this morning around 0800. It was HUGE!

Locust Grove, Oklahoma checking in!

I changed the sending units finally today, and the sending unit were the same. My oil pressure maxes at 30 psi, and will occasionally drop to less than 25psi. What is the normal psi? The engine still runs ok.

It stays pretty steady, idle or driving. It has been closer to 30 than 20. The sending units look to be the same, but I will try to confirm with mech gauge soon. Do I have anything to worry about? The motor runs well with little smoke.

Well, she's a runner! Got her running and took a test drive about an hour ago. Engine seems pretty tight, oil pressure was above 20 psi, but less than 30 psi. That is a little lower than I prefer but everything else was good to go. Ran up to 50mph/2200rpm, I was to gun-shy to go faster, I...

Yep, the tractor just wasn't strong enough. It may have lifted it up of the ground, just wasn't hoss enough that high up. It is a MF tractor 40 hp, with a loader. Used a backhoe to load the new motor on the trailer, and I had a local wrecker lift it into the truck ( and remove the old one).

UPDATE!!!!!!! I picked up the new bullet (engine) from combst32 last night! Just 6 hours of driving thru severe thunderstorms and rain, heavy traffic in Fort Smith, a small exchange of US currency and it was all mine.:-D This new motor must be a different model from the one I had, since this...

Well today I spent the day getting ready to pull the engine & trans, and when I went to lift it out, my tractors front loader wouldn't lift it high enough, so now I have to get a stronger lift. That engine is alot heavier than the small block chevys that I'm used to.:o

Nope, no steam or odor, even after popping. May never know what went wrong.

Ok, in the interest of full disclosure, I have around $2000 in the truck (including wrecker bill) and it is my first MV. I wanted to get one from GL, but the recovery scared me, so I bought local.:cry: Remember, I had only drove the truck for less than 7 miles when it grenaded, so the water...

There was a little noise, that I thought was in the upper end. The truck was very low on power and the temp was around 220, it shuddered and boom. Part of the piston came thru the block, and just looking thru the hole, the bottom end of the rod looks intact so I suspect a wrist pin or...