Recent content by rwminck

Wash Gave the girl a wash and drove her around some.

ColdWarrior, They are definetly not brake-away, I used 1/4" steel and thick wall 316SS pipe. I did not really think of being oversized, but it looks much worse than the picture shows. I will have to go measure. Thanks for the prospective, I would not of thought about it. Thanks

Flag poles Fabbed up some flag pole brackets and put my flags on and drove around a bit

Well, It kind of sold, but I added information to the auction late in the game (only 24 hours left in auction), and the buyer did not read my note before he hit the bid buttom, so I am not holding him to the buy. I told every bidder about the bumpsteer but the winner never asked not one...

Out for a drive Went to Lowes to pick up some pine straw. Real mission was to eval the bumpsteer I was having after installing the new 46's. Lowered tire pressure too 52# and it acts much better.

Thank you very much, that is perfect. Awesome!

I have searched for an hour and can't find any good pic's of a proper tool set and how to tie it down with the proper straps. I am looking to do it 100% correct and taking my time getting the correct tools. Can someone please PM me or post a pic for use newbies to see? Thanks

More Progress More progress: Battery box mount sand blasted, primed and painted, new radiator is in and no leaks after 30 minutes of running. Odd thing is I bought a NOS from a vendor on the site and it is a bit different than my stock. The bottom studs are about 1" closer to the passenger...

Removed the dog bones and blasted and painted the chunk of steal thing, put on the cleaned and painted sling shackles and installed a rubber bumper under the bottom side. Hate the paint on the bumper being chipped by the shackle all the time. Removed the battery box bracket getting ready for...

Thanks AZDeuce, I will give that method a try. Thanks

Just two bolts, that's it Finally got the rear hubs on, then decied I would tackle the front lower dog bones, but could not get the forward pin out. Didn't have 1 1/8" combination so stopped that job. Sand blasted the sling hold downs, prep'd the bump and painted. I was going to just take...

Combat crock pot, Got it. If you need to delete or, understand. Thanks Ralph 3162.

MRE Heater Power? So I bought a MRE/Water heater online and like a doofis I did not check to see how I am going to hook it up. The plug on the heater has 3 prongs. Anyone know a power cord source for this unit? Thanks

That is a awesome story! Thanks

Very cool way to do it! Looks like I need to pre-treat some more nuts with Break free. Thanks Guys