• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Recent content by timmmaaa06

  1. timmmaaa06

    Low engine oil no engine knocking but a wobbling rubbing sound at high RPM?

    Hello I did a stupid thing by not checking the oil and I ran the motor driving around town until a repetitive scratching sound was occurring at high RPM at which I would push the clutch and let go of the throttle. The sound would start soft and gradually increase with a wobbling rubbing...
  2. timmmaaa06

    My "M" won't start

    I am running into a similar problem if you can help I have had the truck running fine and it needed a tune up after replacing the condenser and cap and rotor and points it ran for two days and started to back fire and it seemed the timing was off and the cylinders were all off an it happen all...
  3. timmmaaa06

    new guy looking into a3's

    Looking for a deuce near illinois to test drive and feel Hey I just bought a m37 and I really wanted a deuce I took one for a spin in ohio and needed a little time to think about it does any one know of one I can take for a spin close to Illinois or Indiana or so to really make up my mind I...
  4. timmmaaa06

    53 M37 dodge Turbo

    Hello today I drove my 53 M37 and going from 1st to 2nd the inside of my trans exploded not sure yet of the details of the inside but it the stick is really loose and nothing is working inside. I want to ask of my options in the invent of having to ether get a new trans all together or get new...
  5. timmmaaa06

    53 M37 dodge Turbo

    Hi I was given a turbocharger and was wondering about the posibility of puting it on my M37 Dodge 53 I am not looking for tons of boost or damagin the engine but to increase a bit and to do something with the turbo. also what would be the best way of doing it thankyou.
  6. timmmaaa06

    Drain plug

    Oil pan Gasket Hi I replaced the oil pan gasket and there was a bag with two pencil thin rubber rods I do not know where they go. the gasket cam from napa and is the cork type material. I have a leak in the back of the pan between the clutch and oil pan its self I do not know where if those two...
  7. timmmaaa06

    Can't get fuel sending unit to work.

    I have a 53 dodge m37
  8. timmmaaa06

    Can't get fuel sending unit to work.

    I have a question my fuel sender and guage works but is off by 15 gallons is there a way to calibrate the guage or something also the oil pressure and engine tempature seem low to if there is a way to check them. they do work but i dont know if reliabily. thank you
  9. timmmaaa06

    '51 M37 rear mail oil seal replacement

    by the way I have a 1953 dodge power wagon m37 6 cylinder flathead
  10. timmmaaa06

    '51 M37 rear mail oil seal replacement

    Clutch oil Leak Hi My name is Tim we had a leak in the front of the oil pan. I replaced all the gaskets on the pan and now have bigger leaks in the back of the pan. I do not know if it is between the clutch and engine or what but the oil is dripping down and inside the clutch housing is driping...
Top