Recent content by TLambert

i have an open printer and just starting out. i will try the PLA+. I just printed up the files you uploaded, thanks again. in the future, if i get a closed machine, will try the ABS for sure. Anxious to put them on my truck

i have my printer up and running. i am going to use PLA+ (olive green) and will let you know how it all works out. thank you for the time and effort to create

have you had an opportunity to refine the design? do you have the 3D? interested in adding one to my 998...also leaving house to buy a 3D printer. so mental justification is necessary

i am more concerned about the Rotor side having "extra" pleats and potentially "rolling over" the clamp. if so, the E Bracket will tear the boot. For now, just wanted to pass along that the universal boots can be assembled. it is possible the funnel method would have worked, but the...

Final Install with Universal Boots. I will say, the Universal Boot to Housing and Axle had more clearance than i would like. I was able to get the band clamps to have the boot "tight" to metal axle and housings. but if doing a lot of very dusty or water, could be an issue. i will also add...

Amazon just arrived with Universal Boots. They come with band clamps and grease. Can also get on Rock Auto and other. I bout a $70 Boot Expander. So for a $100~110 on the first go around. But i assume i have three more coming, worth while. I need to grease up and cinch up band clamps...

7k are 0.94" | 3.5" (both ends) 10K are 1.1" | 3.6~3.75" the strap clamp can make up some, but they are definitely different. Summit and Rock have same MFG and PN. I may see if the housing mentioned above will work to salvage my stock unit. worth a shot and i bought boots. i cannot see that...

I may buy one as a JIC to have. This is the second axel in a year that the boot has torn. i don't mind the rebuild, its fairly quick, but the pressed retainer is a PITA. Likely attack it from multiple angles. I can buy a Housing for $125 and add 2 boots and still less than NOS. but do...

I see them on RockAuto for $77 + shipping. I also ordered universal boots, will try the expander over the portal end. The stock 7700# boots (4 pleats) are thick and a no go. I also have the 10k boots which are thinner. I can get the entire 10k housing (Item 12 in the TM) for $125. NOS are...

I have a 7,700# truck and the half shafts have the pressed ring to hold together the Rotor End Housing. Unit is in good working order but the Dust Boot tore. I have had no luck getting boot(s) 5705605/5705606 over the portal end even with an expander tool. Has anyone tried to get the...

I am in the process of upgrading to bucket seats. The older style 12339047 have two retention plates to secure the Support to the vehicle. However these will cause issue when moving to the new seats because of the bolt pattern. I believe the seats will be part of kit 57k3196 or 57K3197 (TM...

correct, the one you mention has 14S-1 style pin. the less expensive plastic connector is not the same.

do you have a link for ebay listing

Planning on 2AWG from battery to front quick connect. Depending on wire routing, maybe 0AWG to the rear. I just don't know why they use 16AWG to the remote since current is low and voltage drop likely not significant enough to cause issue. I do agree with durability and reliability, a lot to...

He mentioned a person from NJ and also Atlanta coming to purchase. I have planned an external set up and one that could also be used on heaver M35A3. The 12' winch is also an option. I am interested to hear about the sender wire. The unit I have is painted over, so wires and labels...