Recent content by TLangM998

A customer wants them for a build we are doing. I didn't ask what anyone thought of the price. I asked if anyone had them or knew someone who did.

I know the connections are spring loaded contacts, so there aren’t any wires, other than that, I don’t know much more. Sent from my iPhone using Tapatalk

Does anybody have a set of these bad boys? Or know anyone who does? They look like they are fairly well built. Couldn't find any reviews on them. Wanted to do a little more research on them before I dropped $5K on them! TIA!

What size hose do you replace it with? Mine is a funny looking hose, almost looks plastic?

Hey Guys! I replaced my oil pan gasket last week because it was leaking in a couple spots, but then this week I noticed a drip forming at the bottom of the crankshaft pulley. Does this look like it may be the front cover oil seal? Anything else it might be? TIA!

Thanks Guys! Do my boots look too squished?

I’ll look into it. Thanks a bunch! Sent from my iPhone using Tapatalk

So my boots looked too squeezed huh? Sent from my iPhone using Tapatalk

So there are 10k and 12k tie rods? Not just axles? Can you tell I’m a newbie?! Ha! Sent from my iPhone using Tapatalk

The only washers the TMs show are on the hub side of the tie rods and I have them there.

I installed new tie rod ends and upper ball joints this weekend, and tightened them to the torque specs via the TMs. But the castle nut goes well beyond the cotter pin hole. Is this normal? Did I get the ball joints and tie rod ends with the wrong size joint shafts on them? I attached some pics...

Thanks Fellas! Gonna tear into it this weekend!

Newbie here! Just wanted to get your guys' take on this before I started taking things apart. Removed my front passenger side half shaft to replace a torn boot, and discovered this... Any ideas on what to look at first?

Are the rear tie rods on the M998 interchangeable? Or are the left and right specific? Can you use front tie rods on the rear? TIA!

Awesome set up! What would you say the total cost was?