Recent content by Troop462

I have not checked the fuel control. How would I do that? No one has played with the main fuel adjustment. My guess is that the FDC is not bypassed. I will have to check.

What you describe is exactly what my Deuce is acting like. I can't wait to see if this solves the problem. It has done it from the day I purchased the truck. Every stop, low idle, sometimes recover, sometimes not. I would have to tap the accelerator to keep it running. Now, after warm up, low...

Found a Parker pump and it's on the way. Good thing I have cool neighbors, truck is sitting in our cul-de-sac. Now the HOA I belong to, different story!

Next step. I have already broke the gasket/seal so will remove again and see. Repainted the bad boy with CARC green sad to blemish all the paint on the screws but it is a military vehicle! Thanks again. My goal is to own a tracked vehicle one day. Very cool you have one. Cheers!

Good question. I pulled the unit and turned on the system. Pump was no go. I need to check to see is it is even getting voltage. The pump was serviced at some point, it was very clean with a new fuel line. This is the first time I have changed fuel filters. Ran fine up until I did the...

That was what I was thinking that my pressure was bypassing. I guess I should trouble shoot the in tank pump.

I did, fuse was good. Took the whole pump out. Looked ok, have not check for power to the pump.

Hi gents, Switched out my fuel filters and discovered my fuel pump is not working. Read that you could attach a compressor and push fuel through the three filters. Added an air fitting on the fuel tank. This is where it got weird. At first I had the frame filter off. Pumped air into the tank...

Will not give my wife that choice, deuce of new house! I will look for the Denton Farm Park Rally. Thanks!

Thanks for the offer! Yep, a bit farther then I would to drive.

Hi everyone, Just relocated to Wake Forest and am looking for a spot to park my Deuce. I am off Camp Kanata and best situation would be covered but outside would work. My HOA covenants prevent my truck from being parked in front of my house, what a surprise! If anyone in the area knows a spot...

M35A2 all done Hi everyone, The M35 is all done and ready for todays parade.

Thanks, mine does not have the adhesive. I have the clips. Guess I will use some type of outdoor glue.

What did you glue the rubber stripping to the door with? I am about to to the same on my 1970 Am Gen m35/A2.

Hey Scott, Just posted an update on the M35/A2 I am going to try to remove the doors again today. Got some penetrationg oil to see if it will break free the pins. Craig