Recent content by WhoMe08721

  1. WhoMe08721

    What did you do to your deuce this week?

    Installed a cab light yesterday & found a cool old Magazine Article on " New Army Truck Runs Under Water" and was think of making it in to a post to hand in my shop.
  2. WhoMe08721

    M35a2 Intake Manifold Bad Casting Or Rusted Out

    To Many $1000.00 For A NOS April 2017 Box Data
  3. WhoMe08721

    M35a2 Intake Manifold Bad Casting Or Rusted Out

    Was Able To Look At (4) More Intake Manifold This Weekend and I Have Came To The Conclusion That the Sand Molds They Use For Casting Where Not That Good Back In The Day And That Mine Way OK. I Also Finally Found A New Radiator For Sale And Got It Installed This weekend.
  4. WhoMe08721

    M35a2 Intake Manifold Bad Casting Or Rusted Out

    Hey Guys, Was removing the radiator and thermostat today and notice that my intake manifold is a little mess up inside. Was this a bad casting from the factory or is this rusted out. Should I be worried about this??? Attached are some picture.
  5. WhoMe08721

    M35a2 ARB Air Locker Questions

    Final finished all the little parts on the air lockers and been using them in the mud. Best upgrade I have ever done to my m35a2.
  6. WhoMe08721

    M35a2 White Smoke

    Hey Guys, Final figure out where most of my smoke was coming from when idling. Since march I have been running a 75% used oil to 25% diesel which lower the rpms at top speed and the truck runs a lot better over all. But the smoke was still there till last week I was under the truck and...
  7. WhoMe08721

    Air locker opinions

    I Did all 3 axles (ARB Locker) about 2years ago and it was the best thing I have ever done to the truck. The Job was not hard at all, the only thing I wish I know before hand was you have to grind the top of the diff housing for the new air diff.
  8. WhoMe08721

    What did you do to your deuce this week?

    Got some paint on the troop seats today & finished wiring the wipes.Best move ever to upgrade to this type of wipe, plenty of power and no noise like the air ones.
  9. WhoMe08721

    What did you do to your deuce this week?

    I did all 3 axles. This project all started when I got suck in a large mud hole in the Pine Barrens 2 years ago and had to be pulled out by a 5 Ton. The tuck went on a angle in the mud hole and all 3 tires came of the ground and I could not move. That day I decided to tackle the project. But I...
  10. WhoMe08721

    What did you do to your deuce this week?

    Final got a lot checked off the list of thing to do in the last two days. Got the air lockers all done, the right way. Replace all the door seals and window seals and Raptor Bed Liner Inside The Doors while I was in there. I got the New Fuel Pressure Gauge installed and installed new shifter...
  11. WhoMe08721

    What did you do to your deuce this week?

    Final Got The Light Bar Mocked Up Today. Now Off To Paint:)
  12. WhoMe08721

    What did you do to your deuce this week?

    It's a custom clean diesel fuel tank I made for my arctic heater. I don't use the main fuel tank to feed the heater because at the beginning of this summer I started to run 90% used motor oil and the truck love it. The rpm went don't and just over all it running better. The only problem I have...
  13. WhoMe08721

    What did you do to your deuce this week?

    Final Installed New LED High Beams & Started To Build A Front Windshield Light Bar Bracket This Week
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks