Recent content by Zai

Parts urgently needed!!! ASAP!! Please help. Hi, I know this not really the right place to post this however I am trying my luck anywhere and everywhere. Below is a list of parts I need as my company vehicle (custom vehicle built over a MAN Kat 6x6 chassis) has gotten stuck in Baltimore MD and...

Parts Needed ASAP!!! Hi, I know this is for parts found but I am quite desparate here and considering I will not find new parts I am looking for I figure salvage is the best bet. Below is a list of parts I need as my company vehicle has gotten stuck in Baltimore MD and urgently requires the...

MAN Kat 6x6 parts needed ASAP!!! Hi My company truck has had some mechanical issues and is stuck in Baltimore, MD. It urgently requires the following parts for Magirus Deutz V10 Air Cooled no 7787902 type F10L413F.- Flywheel, number on part R6635. It was machined in June 2016.- Pressure...

The truck weighs roughly 18tons. That is with full load as it is not used to transport heavy loads. The transfer case appears to be completely attached to the transmission. Are there better transmission to use instead of Allison? Possibly Eaton ones?

The engine is very old and has been overhauled and then constantly repaired along the truck's journey. It has now gotten to a point where it is consuming massive amounts of oil. It also produces a very heavy thick black smoke when driven and nothing reduces this. Due to emission regulations we...

I am located in South Africa, however the truck will be in America when the engine replacement will be done. The truck will be in Orlando, Florida to start off with and will move around a lot so can engine replacement can happen in a variety of states. Because I am not entirely sure where it...

Hi everyone. I am looking for any information on replacing an engine of a MAN KAT 1 6x6. The current engine is causing so many issues and needs replacing, however I am struggling to determine what possible engines can replace the existing one without needing to replace the whole gearbox as well...