Recent content by Zero_cool

Thanks timarr just ordered them from ORD and sending the ones back to the stealer. I should have went threw ORD in the first place...WAY cheaper. I paid $60.00 for 2 bushing at the stealer and they didnt even fit.. cshaw07 Ive been driving it around town without the sway bar but Im due for...

What did you end up doing with this? I'm having the same problem. Part # 328128 from dealer was to big. Bushing measures 1 9/16th'' the sway bar eye measures 1 5/16th. What makes the 2 piece bushings from ORD easier to install? Are they smaller then the ones I have or is It because there a 2...

You have to rotate the engine untill the screw lines up with the hole. 15/16th'' socket on the crank pully rotateing it clockwise while yur helper looks down the hole. Turning adjusting screw clockwise will advance and counter clockwise will retard fuel. 1/8th turn for N/A engine 1/4 turn...

I replace the glow plugs in my 1028 the winter before last with 60gs. It has been working great ever since but now they stay on for 35 seconds on my morning starts. The air temp doesnt seam to change this -30 or +80 its allways 35 seconds unless i plug my block heater in then its only 8 seconds...

If you have really small hands you can reach the pink wire on the top... To replace the ground you have to drop the tank , the ground wire is soldered on. I drilled a small hole for the ground wire and attached it with a small bolt. Dropping the tank is easier with the box off but not nessasry...

I have a orbital blowout fracture so my vision right now is not so good. I got my puller from my dad, but you can find them all over the internet ranging anywere from 50 - 100 + bucks. all it is is a tool that pulls the swollen plug out in a straight line. Your plugs might not even be swollen...

Depends on how swollen they are. There is a tool for pulling out swollen plugs, pretty spendy but in my opinion is worth it. Hard to see the card in your pic , but you can do a visual inspection of the tape and all the soder points. Do you have a pic of the other side of the card?

Thats where I put mine to. Last winter I had 3/4 covered and it was ok. Ive been wanting to get a winterfront from JATONKA for a while now so as an experiment I tryed a full piece and she overheated. I even cut 2 holes just like the winterfront but it still overheated I just dont see why the...

Do you guys have any overheating issues when you use your winterfronts? I put a piece of cardboard in mine and it just made it overheat.

Well I finally made it in to the DMV...MAN were they rude! They said that they go by the vin of the vehicle. If the vin says its a 1 ton then that what I have to register it as. Then she said it has to be 10,000 or more pounds to be a 1 ton. When I told her that the GVW was like 9,400 she said O...

lol i thought for sure you were gonna get drenched. Sweet vid

Wow now thats a different story. I dont blame you for being pissed. Can you confirm that he is working on it now? If not I would go down there and get my money back and take it to a different shop.2cents

Man that sux. Do you think hes just jerking you around or mabey hes got a lot on his plate? Is there a different shop you can take it to?

Hey did you ever get your rig fixed?

I thought about that to, but they said In order for me to drive it it would have to be related to a car show. This is my daily driver so that wouldn't work.