Search results

bad regulator Mine did the same thing, cold fine, drive it 3-4 miles and it would peg the needle in the red and belts start to scream. This was a new regulator after the first one died. Ended up replacing the 2nd regulator with another new one and works just fine. Alternator repair shop...

blown out of the water on m931's again. Oh well, keep on trying.

Same problem with mine. Got a new voltage regulator from Eriks Surplus. 3 wires to hook up and your done. with shipping it was only 72.00

I seen those trucks down there while picking up a trailer. They looked like they just came off the factory floor. Somebody got some real nice trucks.

I did not notice any change to mine, but I have air assist steering. I think the air assist mask any steering gains the lock outs added.

It's as simple as reading the rules that are in ENGLISH. Clearly states that you can't post about an active auction. Be generic as possible and the moderators will not toss s**t at you like you think they are. The rules are not that hard to follow. Yes, I have a low posting number, but I...

mikeroot2, that looks the same as one I got last year off ebay. Said it was a 5 ton, but the spline is too small to fit on the deuce shaft. I hope you have better luck than I did. Same price as mine and it was a no return auction.

You have good luck like I do.

Been looking at several sites for awhile. Couldn't not find them any cheaper than racemart. Pulled the plug 2 days ago and ordered them. Fed ex says friday get them.

I still have the instructions that came with mine, but they are on paper like 2 feet by 3 feet witht the old blue mimiograph blue ink. So about at clear as an ink blot. I can try to photo copy each section and send it to you if that will help.

If you need a radiator, I have a new one in Lapeer area. PM me

Ok Thanks, good to know.

I want to change from old style 2 pin positive/negative slave plug to newer style round slave plug, positive center pin and negative outer ring. The old style was negative isolated at the plug from the chassis. With the newer style plug it wont be since the negative section is part of the...

mep-026c, 10 hours on it, built in 1969, rebuilt carb, added oil and filter, fires right up.

Mine would only run on either shot. Took carb apart, all the cork gaskets were dried out. Used gas resistant atv sealer to "make" new gaskets. The fuel pickup in the carb was gumed shut, clean that with oxy-act torch tip cleaner. Fuel shut off handle was installed backwards so no fuel to...

Always nice to have another Michigan member aboard!