Search results

My parts list: Same as on Ronmar suggested on his video Qty Item No Description Amount ****************************************************************************************** 1 9-3800-4-4 JIC 4M x 1/4 BSPPM CONNECTOR...

I've also followed @Ronmar video instructions on the pump upgrade. Alot less complicated than the older system and pretty fast to bring up/down. Thank you @Ronmar for sharing it. @InvictusDecretum did you order your alternator brackets ? I've the same alternator in a box waiting for when...

5 LG 440watts each

I might need to get one of the new alternator kits later if the 2kw of solar becomes insufficient.

Are you running on the 260A alternator or aftermarket retrofit ?

Thank you. Real world experience is worth a lot of opinions.

Thank you, will work on this. Looks like I should setup my Battery to Battery charger Low Voltage setting to 27.6Volts (Lead Acid Float voltage) this way the vehicle batteries are charged and then will be time to move power to the LiFePo4.

The alternator is the secondary charger, in case there is not enough sunlight.

I looked at Victron, and I didn't like the enclosure not being water resistant , the lack of control features and the small current output. I should get 27Amps of one device and the goal is to add 2 for about 50Amps total. They will be installed inside the battery box. The price is also more...

The ACC (yellow wire) on the device will turn on charging if voltage is 10-40VDC, bellow that it will remain off. It's just for turning on. The real load goes under the other terminals. Besides the ACC wire I can also set an under voltage protection, so I can ensure I don't discharge the...

I’m using the standard 100amps alternator 24V side to charge a 24V LiFePO4(bank. The charger does up to 800 watts and I can set the max voltage and turn it on/off via RS485, it also has the yellow cable that would turn it on only when voltage is present. So it sounds like I need to invert K11...

I'm trying to connect a battery to battery charger to my M1083A1, the device has an ACC/Enable port. I'm trying to identify a place I could connect it so it would only enable when the truck engine is running so it would use the alternator and not discharge the batteries. Does anybody knows if...

Did you already checked with Grigsby ? I've waited almost 2 years for mine, but they did deliver.

Here is the 6x6 manual for reference TM-9-2320-366-34-4 Page 765

It will depend where you will drive. Mud, snow ?

Just want to add as a reference here. There are two type of idler pulleys and they require belts of different lengths. Source PS 798, page 19 https://www.psmagazine.army.mil/Portals/74/PDFs/Archive%20Numbered%20Issues/PS_798_exp.pdf

From a vendor. I don't have a way to put a direct order. Same vendor also has other clients waiting on it.

I’ve no other choice and I’m not using the truck. Would have cancel already if I had another option.

What's the price ? Do you offer Warranty ?

FYI: I've placed an order on Fox shocks March 15, 2021 and I still have not received the shocks. At this stage I'm ready to cancel my order and go with Monroe or anything that is available.