Search results

Anyone know what the PSI into the carb is supposed to be? Thanks, Captain Jack.

Ive got a M715 with 35-12.50 R16LT Super Swappers on it, and still using the original lock ring rims. Ive just had my 98th flat tire again due to the inner tube. And in the process of changing the tube out, I about took off my thumb. Where can I get some rims for the M715 that will fit the...

Blew the oil line that runs from the back of the oil pressure-sending unit, to the back of the engine. Dose that hook up to the back of the valve cover? Where can I get one soon, and if it dose hook up to the back of the valve cover, a new valve cove gasket. Thanks, Nate

I just got a 24-volt heater for my truck. Dose anyone have a diagram / Know where the hose connects up to the engine, and then to the heater, and from the heater back to the motor. I see a plug on the back of the water pump, but I can’t find another plug anywhere. Any info would be much...

On the M715’s Carb, after rebuilding the Carb, is the idle –mixture needle backed out about a turn and a ½? Any suggestions on a different carb? Thanks, Nate

Anybody have a “Vacuum line” diagram? All mine are just plugged,were whaen i got it, but id like to get them right before I go to an electronic ignition. Thanks, Nate

Ok, another idea I want to run past everyone. When I got rid of my other truck, “24 volt” I had a 24-volt to 12-volt converter in it that I kept. The converter will handle up to 25 amps, but only has 10-gage wire coming out of it. Now the winch’s manual says it only uses up to 12 amps max, but...

Hay, anybody ever add a 2nd alternator and battery in the back? I want to toss in a small 4000lb utility winch in the bed, so I can get a hand lifting things into the back? Thanks, Nate

Anybody have an idea on where to get the clips that hold the bracket onto the window inside the door? Thanks, Nate

Hey, my 1967, M 715, has been running great, started without ever even touching the gas peddle. But last week the O ring in the carb went out. Cleaned it out and rebuilt the whole card, reset the points, and now I have to press the gas peddle a number of times just to get it started, and as...

I have the real 1967, M715 Jeep Gladiator Military truck 1 ¼ ton, not the wagoneer, with a Dana 60 front end. When I pulled the Hub off, it has a 21 Spline axle with 6 large bolts holding the hub on, not Allen screws. Dose anyone know where to look for that? Thanks, Nate