Search results

Does anyone know what this harness was connected to, its the red and white wires on an M1165 A1 under the left side hood next to the blackout light and turn signal wiring.

Does anyone know what this harness was hooked up to, its a red and white wire under the left side of the hood on a M1165A1.

Does anyone know where I can get the air/fan decal for the M1165 humvee

Got a little acetone on my temperature gauge lens and now its foggy, I have a bad gauge with a good lens and wondering if theres an easy way to take apart the gauges so that I can swap lenses.

Is there some type of adopter available for converting the humvee light switch to rocker switches ?

Does anyone know what this is used for? The harness pictured is connected to the negative post and comes out to this box at the rear left corner of the battery compartment. Relocating my batteries and wanting to remove any unused wiring.

Working on my butchered instrument cluster wire harness on my 1165 with electronic speedometer and traced most of the wires and marked them with the correct numbers. A few wires are not shown in the manual and im looking for some help on these. Basically 2 cut wires attached to my cluster...

These are the 3 wires that attach to the side of the starter. Unfortunately they were cut before the tag and im not sure if I actually need them, the start does work without them

Does anyone know what this cable is and what its used for? Its underneath the left driver side of the vehicle in front of the transfer case. The nut is missing from the bolt and not sure if I need it.

Planning on changing the gear oil on the rear differential on my M1165 but not sure where the fill hole is, I see a fill screw when looking at the differential from the rear but not sure if its for the gear oil or something else.

The linkage bracket attached to the side of the transmission pan was removed during govplanets demill process so I mounted it back on with a few bolts from the hardware store and noticed that there is a leak from one of the bolts holding up the bracket. The bolts are tight and I did replace...

I finally got my humvee running but im hearing a knocking noise from the right rear axle when I took it for a drive, I can hear the noise even when the vehicle is rolling in neutral. Has anyone experienced this problem and maybe can give some advise as to what may be the problem?

Does anyone have a battery cover/passenger seat base for an M 1165 humvee

Trying to figure out the missing wire numbers for my gauge cluster which had been cut by govplanet. I did look at the wiring diagram and the only wires which I think I figured out are the 2 wires next to 36A, I think they are 36B and 33 but please correct me if Im wrong. I would appreciate any...

Trying to install a replacement gauge cluster on my 07 humvee 1165 with the electronic speedo but it came butchered from gov planet. The wires were cut and number tags are missing, does anyone have a wiring diagram for the cluster. Also which terminal would be the positive terminal on the back...

I removed the air filter housing last year and now that I'm finally near completion of my built but I cant remember where the middle strap goes around the filter housing. I couldn't find where the middle strap attaches to , any help would be appreciated .

Relocating the batteries on my 1165 and will be needing the seat mount rails that are riveted to the floor, these are the floor rails that the seats mount on. Does anyone have a part number or maybe suggest a supplier who may have them available.

Im installing a set of aftermarket wheels on my humvee and need a longer lug nut but read somewhere that they should be a locking lug nut so that they dont back out., can I use a standard 9/16 18 nut without worrying about losing my wheel while driving?

Getting my Humvee ready for painting but couldn't remove the wiper arms. I removed the small allen screws from the side of the tubular body connecting to the shaft but I wasn't able to pull out the arm, is there something else that needs to get unscrewed?

Looking at a humvee inspired gorilla body kit on line and it looks like the dash and center console may work on a military humvee so I contacted the manufacturer to see if their center console would fit over the military doghouse and was told that they are not sure if it does. Has anyone here...