• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. S

    My new cucv.....couldn't escape the forklift :(

    Mine cracked also but between the trans and tranfer case on the adapter/coupler. Check again and see if thats what broke. Its the piece that goes to the cross member holding up the transmission. If its that its an easy fix just drop the transfer case and change out the adapter. My driveshaft...
  2. S

    M1008 voltage regulator

    No chance I mixed up the wires they had rubber caps on them with two wires going to the pos side and one wire going to the neg side. No sparks just after about 3 seconds it starts smoking a little and I pulled the batt cable back off. I swapped the alt to the drivers side and ran it with the...
  3. S

    M1008 voltage regulator

    Where do I get a diode plate and what does it do? Thanks
  4. S

    M1008 voltage regulator

    I wonder why they are starting to smoke. I have 12 volts from the ground pin that goes to the other alt. and 24 at the large pin with a smaller wire and large red wire . There is 24 to the red wire on the two wire plug and I'm not sure what the other wire is.
  5. S

    M1008 voltage regulator

    Does anyone know the part number for the passenger side alternator voltage regulator. Is it a 24 volt regulator? I bought 2 different voltage regulators for it and both start to smoke when I touch the battery cables to the battery. The original was overcharging the back battery and didn't...
  6. S

    Help with Rough Country 4 inch lift

    Front and rear are wrong. It looks like superlift front kit might be 3418 just need a number for the rear u-bolts for a 4 inch block.
  7. S

    Help with Rough Country 4 inch lift

    I got a 4 inch lift with front springs and rear blocks but the u-bolts are for a 3/4 ton and won't fit the dana 60 and corp 14. Can someone tell me what ones i need and where to get the u-bolts? Thanks Scott
  8. S

    Transfer case adapter for m1008

    PM sent
  9. S

    Transfer case adapter for m1008

    I am looking for the M1008 transfer case to tranny adapter np208 to th400 mine was broken by fork lift.
  10. S

    m1008 electrical problem

    Got a m1008 with 44000 miles drove it home after a jump with no problems. When I jump started it later the dash started flashing the dash lights low coolant, glow plug, and the horn started sounding voltage dropped off and back up and then something smelled hot so I shut it off. The little...
  11. S

    m1008 plow set-up

    Just put the 61770 on my m1008. The arms just clear the sway bar . The right side arm has two holes that can be drilled it was the lower one on mine the upper hole has a fuel line behind it. You have to remove the front bumper to slide it in and its a tight fit because of the tow hook...
  12. S

    M1008 won't come to life

    How about the relay under the dash
  13. S

    Strange coolant leak

    My m1008 just leaked in the same area but mine had three small pin holes on the bottom side of the heater core hose where the heater core flares out after the hose clamp.
  14. S

    Shakes me to death when i go over a good bump

    I just fixed the same problem. I thought the front tires were jumping off the ground. Went to advance auto and bought a steering stabilizer the one on the truck was shot. No more shaking on my truck. Try that first it cost 34 dollars if that doesn't fix it look at the steering linkage and...
  15. S

    Need info on m1028 engine setup

    I picked up a 1987 M1028 today with 21000 miles but the engine has two huge alternators both on the passenger side and an ac unit installed on the drivers side that the lines go through the firewall and it has ac control switches on the dash. There is also a blue box on the drivers side fender...
  16. S

    Need m1008 rear bumper

    search ebay for m1008 there is a guy in nj that parts them out too.
  17. S

    Need m1008 rear bumper

    link Chevy M1008/M1009 military rear bumber:eBay Motors (item 170355938850 end time Jul-16-09 12:06:15 PDT)
  18. S

    Need m1008 rear bumper

    E-bay has one now.
Top