Search results

That is one heck of a front bumper. Where did you get that thing?

Ya the little ring is a pop off ring (not really a washer). Its one of those things that you can remove with the flick of a screw driver.

Well I got to the junk yard and got my adapter. Now I just need to wire it in. If anyone has wired one of these units in before where did you wire it too? Or does everyone agree with what M1009 Fiend has said in his post above?

Are those the 10.5 or 12.5 33's? And do you encounter any rubbing at all when it turns or off roading?

Radioshop: What about int he fuse box, is there a better fuse to tap into?

Well the hand held clamp was already where it is in the truck. So to avoid to many holes and the truck looking worse than it already is. So it stays where it is. As far as where it is hooked into where would you have tapped into that would be safer on my truck?

I removed the tailgate today and brought it inside (raining outside) stripped pretty much the whole thing down replaced the lock cylinder and now it still wont work. Inside there is a little ring on the backside of the clutch that doesn't seem to really hold anything on. I seriously feel...

So I got my new lock cylinder for my M1009 tailgate lock from LMC, and after some probing around I realize I have no idea on how to do the swap. I don't want to rip the entire tailgate apart but if that's the route I have to take then so be it. Anyone done this before that could shed some...

Nice. have to take a ride to the junk yard tomorrow and see what i can snatch up.

Thanks I cant find one of these online either. I might have to visit the local junk yard and get one myself. Have any ideas what tools I will need for removal?

So as most of you that own the M1009 Blazer, I don't have an AC adapter (cigarette lighter), however I do have a spot for one adjacent to the ash tray. Has anyone installed one in their M1009? I would like to have the ability to run stuff off my truck, such as a spotlight, air compressor...

Well the project was a success. But i will walk you through what i did so that others may learn. First off I mounted my cobra CB in the truck. As you can see I mounted it to the two bottom ash tray screws. This actually didn't work with the way the stock bracket was (slots were to close...

Stock rims?

ok found a few things Defender Roof Racks This is what has been referred to me for a roof rack. Kind of pricey but should look really nice atop the shell. Car Part Wholesale - Auto Parts and Accessories Catalog - Light Bars And this is what I was told was a good sturdy light bar. Thanks...

So I am going to install my CB in this weekend. Just one small question before I do though. What fuse (or fuse location) is the accessory fuse? That's what i plan to tap into. Also want to mount a speaker under the hood for an intercom (will hook up to the CB) so I also have some minor...