Search results

From the pic it doesn't look like a factory AC air box. I'm betting this is a (Nostalgic AC Kit). I've seen some M1010's on the government auctions that were retrofitted with them buy the military.

Why not use the studs?

Yeah head gasket:-x.. I've come to the conclusion that ALL these trucks should have they're head gaskets replaced.

Can you tell where the coolant puddle was coming from?

Found this pic on instagram

Incase you didn't know there's also rubber fuel lines that run under the intake.

Replace ALL rubber fuel lines, and recheck your filter fittings. Did you use thread sealer on the fittings? Also a neat little trick is to temporarily replace the return fuel line with a clear hose to show if any air is entering the system. The (return line) is the short hose coming out of the...

Well if you feel you really need a light. why not have it indicate the FULL warm up cycle. And go off once the high idle turns off.

Agree with (cucvrus) & (tow4). Keep it simple so it can be easily serviceable. If you've done the Dog head relay mod (like you should have). The voltmeter will drop and there will be an audible "clunk" when the relay engages.2cents

Off road design makes a set of greasable leaf spring bushings. I installed a set of energy suspension poly bushings on my front leaf springs a few months ago. And as of yet I haven't had any squeaking. But if it becomes an issue I my swap out to the ORD ones.

Poly bushings will squeak if you don't grease them. New ones usually come with a packet of grease.

https://www.youtube.com/watch?v=4-Vck6oCi3A

Ahh it's working on my end? It's an electric motor that bolts to "any" engine and is belted to the crank shaft. It acts as a power adder.

https://www.youtube.com/watch?v=4-Vck6oCi3ASaw this on youtube and thought it was interestinghttps://www.youtube.com/watch?v=4-Vck6oCi3A

Agree, as long as you have a good, fresh, 50/50 mix of antifreeze. I see no reason to use the block heater unless you know your going to drive it.

I think I know how the water got in. About a year ago the master cylinder cap developed a leak, and it took me a few tries to get it fixed. However I think you may be right about the flex lines (Rustystud). Ever sense I did (what turned out to be) 4" lift on this truck, the front flex lines have...

Just search 1984 chevy K30 Pickup.

Don't worry, you needed to do the head gaskets anyway. These are 30 + year old trucks, the head gaskets are crusty and would probably fail anyway.

LOL!! (S.S.B.C.).... Stainless steel brake company it's a DOT 5 silicone, over priced brake fluid $$$$

Yeah, SSBC version, I just used Napa brand this time.