Search results

I have a MEP 004a and the RPMs don't get high enough to keep the Hz up. Max speed the Hz are at 49. That is the max. The Hz adjustment does nothing. I can move the throttle in almost all the way and the RPMs don't change. It's like the fuel pressure is too low. I have no idea how the day tank...

Reversed everything and on 3 phase it works ok. So something for that is not the same on my set. Still would need a schematic to track that down. I have a problem with getting the RPMs up there most likely a fuel issue.I'll start another thread on that.

I am working on a mep004aas and I was getting voltage but the freq. meter would not display anything before. I was advised that this is due to not having a load on the unit. I did the conversion as you describe here and now I only get voltage if I hold the start switch up. As soon as I release...

If going to a straight pipe is there a source for the flanges? Seems like a pipe from the bottom flex el to the top would be best instead of 2 parts. 4" I think it is.

Same exact thing happened to me (M931A2) and a friend said it was mostly due to cold fluctuations in winter. It says to tighten by hand and only hand tighten it. Yep that worked for about 100 miles. Tightened again and got 250 miles. Got ticked and used a strap wrench I had in my tool box for...

Valve spring? :-O OMG in that category of explosives for a flyswatter! LOL I think I remember reading that it actually didn't crush your filter either. Amazing TBH. TY for the offer. Let me give it a few to find something like original and if not I'll take you up on it. :) I was looking into a...

Thanks for confirming the dipstick part for me. I'll move the other to a classified ad just to be safe. I was on the fence if it was actually going to be a request or a just an ask for where to get something. Does that go there to? one way or the other I'll move to be safe. I have done a lot of...

Just picked up a MEP-004-AAS and trying to get it ready for a trip to run welder, hand tools and compressor. Did the single phase conversion listed here: http://www.steelsoldiers.com/showthread.php?78616-re-wiring-my-MEP-004a-for-different-voltages-including-single-phase and have not tested it...