Search results

O M G.....That's just what he needs.:funny:

Tell your little office buddy to get a truck and come on out. :driver:

I will be there. Python86, are you coming?

Might be part of my problem. I think I used whatever white teflon tape I had lying around which was for regular plumbing. Hmmm, how long ya think before leak starts again? I could tell previous leak because the bright white teflon turned a dull cream color where the leak was and the fittings...

I also installed the secondary kit from Westfolk. Mine developed leaks around the fittings on the filter housing itself causing fuel to pool on top of the filter and drip down. I had to take everything apart and tighten them up quite a bit. Now ll seems to be good. I'm quite happy with the...

You are not bypassing the pump. The engine will draw enough fuel to run the truck through the IP. The in tank pump keeps fuel pressure to the filters, system and IP to purge air and allow filters to be changed etc so the canisters fill back up and air gets out. if your in-tank pump is...

Yes, take both of them off to fill them first, then tighten them back up same as just changing the filters. And make sure the vent bolt is tight/closed before you crank it or you will suck air in.

Definitely check the in-tank pump. I had same issue when I changed mine. No fuel coming to flters and my in tank pump was running. When I removed the pump to check it, the bottom had fallen off. Once that was repaired, it pumps fine and I get fuel to the secondaries and can purge the system of...

Do youhave the link or part number to the particular Airtex pump you are referring to?

I should be back on the road by then and will be there.

You got a picture? Are you referring the fact that the batteries run in series and one of the negative cables from one battery goes to the positive terminal of the second battery? Or are you referring to the fact that the positive cable (red) that goes to the starter etc. is benig used as the...

:ditto:

Di you find out if the 3 fork plate for the 5 ton would work? I'm curious myself.

Ok, the weather broke and I finally got off my lazy tail and took some picures. I took a piece of vinyl siding pictured. Cut only to about 1 1/2 to 2 inches wide and use the channel portion at the bottom. I then took pliobond and secured the siding to the top edge. I then took 1/8th inch large...

That would be for a one piece correct? The two piece one I have would not be long enough to do that. I'm guessing I was sent the wrong strap.

Am I the only one that can't figure out how to attach the Jerry Can strap? I have seen some unbolt the can bracket bottom plate and run a single stap underneath. The one I got was a two piece. One of the pieces was already sewn in a loop but the only way to secure it to the slot/hole would be to...

Ok, the weather broke and I finally got off my lazy tail and took some picures. I took a piece of vinyl siding pictured. Cut only to about 1 1/2 to 2 inches wide and use the channel portion at the bottom. I then took pliobond and secured the siding to the top edge. I then took 1/8th inch...

I had same issue, mine is a 68. Sprag would not engage properly. Did all adjustments per TM, still would not work. Then it began engaging/disengaging occasionally making terrible banging noise and jerking the front wheels. Had to disconnect the front drive shaft which has solved the problem...

Mine also had the wire removed from the horn when I first got my truck. I connected it and it seemed fine until one day when I turned the steering wheel it went off and would not stop. Obviously it had been disconnected for a reason. Turns out the wires were frayed inside the steering column and...

Is the truck parked on level ground when checking?