Search results

Yep, would be very interesting, but considering the 5 solid = fatal fault coming from the manufacturer does not indicate this is possible… but they are in the business of selling modules:)

What General said, they should have used the word drain. You open the drain and use the pump to pump out the water/fuel sample from the bottom of the filter bowl. That is actually one way to confirm if your bypass flapper is sealing. If you open the bottom drain, nothing should happen except...

also check the K26 path to ground.

If you pre-fill the filters, it doesn’t take much to re-prime. It would take quite a few to fill dry filters…

Did you look at the run out of fuel video I did right before the primer C&I? That shows how you use it, and how it is supposed to work…

Yea this is not an RV slide-out that only needs a few hundred pounds of force to operate. Tons of electric actuators 100-1000# capacity. Pickins get pretty thin above 1K# of op force…

And that has been a fairly frequent question over the past few years, both here and in other groups since I joined this club. “My CTIS has 5 solid lights”, mine included… That failure alone in what is a relatively small community puts CTIS into the high failure category IMO, not to mention...

Any of the “bad" units that you have tested good have 5 solid lights?

yea a >5000# electric linear will be expensive. It may also not be very fast... There is a reason we do so many things with hydraulics:) Sounds Interesting, Good luck!

Well K26 is driven directly by the transmission. Do you have both transmission inputs, Battery and IGN? Allison controls some outputs by providing a ground, and others by providing a voltage. The voltage it uses for output is the battery input. Thats why the Vehicle interface Module on the...

Check my YT channel username Rronmar. Did a vid on the typical primer issue and resolution. Not sure which port you pulled on the primer assembly, but that may keep it from working... 16-18 pumps to lift fuel from tank to primer with an empty line, ~20 more)with full filters) to feel...

Remove the passenger kick panel. Its mounted to the underside of the dash. Molded aluminum case with heatsync fins and a cannon plug connector…

well if brakes work while hazards do not, relay K-10 switches between the two, and since it energizes when brakes are applied, if it is a 5 pin relay(has de-energized contacts), that would point me toward the flasher assembly. You can simulate flasher input by disconnecting its connector and...

All but one center rib and the wheel well half ribs are fit, most of the floor structural welding is complete.

Hey wait, I want a cinnamon bun!

You might think it a noob clue, but there is no such thing. Observation is observation… Ok, the only relay indicators that would flash with Hazard or turn are the trailer light relays that switch 24v to power commercial 24v trailer lighting, K30 and K31. You say the green LEDs flash but does...

Strength would be a bigun… the rod end side of the piston(side used to lift the tire) has ~ 2.36 sq/in of surface area. It takes ~2200PSI to lift the tire, so that is 5,183# of force from the cylinder to lift the tire…

Ok, as mentioned, grounding, or light sw, or flasher unit, or TS switch on the column Or hazard sw in the dash as it provides all power to the flasher… next time it happens note if relay K9 is energized or de-energized. It gets its power from the light switch via CB74 and it provides the power...

When the TS don't work, does the hazard switch turn on flashers?

Left side floor ribs in and welded.